Growonix XL UV Filter - 6 GPM - 120V - 1/2-in Quick Connect

Ultraviolet Water Treatment for Hydroponic Supply Lines - 6 GPM

Microbes in a well or stored water supply can foul reservoirs and lines in hydroponic systems. This stainless steel ultraviolet filter treats water as it passes through, with no chemicals added. A 32W ballast drives the lamp, and an audible alarm alerts you to a problem so you do not have to guess whether the unit is working.

This single unit suits growers who need a dependable treatment stage on a supply line, from a home setup to a small commercial room. Check that your flow demand stays within its rated maximum flow.

Key Features & Benefits

• Max flow of 6 GPM — handles typical supply-line demand for many cultivation setups.
• Audible alarm — alerts you to a fault so water does not go untreated unnoticed.
• 9,000-hour lamp life — lets you plan lamp replacement around a known interval.
• 1/2-in quick connect input and output — makes installation and removal straightforward.
• 120V supply, 32W ballast — runs from a standard 120 VAC outlet.

Who Should Use Growonix XL UV Filter

Growers using well water, storing water between uses, or adding a treatment stage to a Growonix XLSCRUBBER, CX4000, CX7000 or CX10000 system will find it a direct fit.

About Growonix XL UV Filter

Growonix makes water treatment equipment for hydroponics. The XL UV Filter is a stainless steel ultraviolet unit rated for 6 GPM and a maximum feed pressure of 125 PSI. It fits the XLSCRUBBER, CX4000, CX7000 and CX10000 systems.

Frequently Asked Questions

Q: What systems does it fit?
A: It fits in the Growonix XLSCRUBBER, CX4000, CX7000 and CX10000 systems. Confirm your model before ordering.

Q: What is the maximum flow rate?
A: The unit is rated for up to 6 GPM. Higher flow should be split across more than one unit or reduced.

Q: How long does the lamp last?
A: The lamp is rated for 9,000 hours. Plan to replace it at that interval.

Q: What does the audible alarm do?
A: It sounds to alert you to a unit fault. This helps you avoid running untreated water unknowingly.

Q: What power does it need?
A: It runs on 120 VAC and uses a 32W ballast. A standard 120V outlet supplies it.

Q: What fittings does it use?
A: Both input and output are 1/2-in quick connect. Adapters may be needed for other plumbing sizes.