HydroLogic® HyperLogic® Poly-Spun Sediment Filter - 20in x 4.5in - 5 Micron - Single Use

HydroLogic HyperLogic Poly-Spun Sediment Filter -- 5-Micron Pre-Filter

The HydroLogic HyperLogic Poly-Spun Sediment Filter is a single-use, 5-micron melt-blown polypropylene sediment pre-filter engineered for use with HyperLogic water filtration systems. Capturing silt, rust, dirt, sand, and other suspended solids at a 5-micron level, this filter protects downstream filtration components, including RO pumps and membranes, from particulate damage and premature fouling. Positioned in the gray housing under the RO on HyperLogic Commercial Series systems, this filter provides OEM-level pump protection; on Industrial and Heavy-Industrial Series systems with CIP units, replace it after each CIP run to capture removed membrane scale.

Key Features & Benefits

• 5-Micron Melt-Blown Filtration: Melt-blown polypropylene construction provides consistent 5-micron particle capture throughout the depth of the filter media, not just at the surface.
• Protects Downstream Components: Capturing sediment, rust, silt, and dirt before they reach RO membranes and pumps extends equipment service life.
• System-Specific Sizing: Dimensioned for exact compatibility with HyperLogic filter housings -- 20in x 4.5in for correct fitment and seal.
• Replacement Interval: Replace monthly, or after each CIP cleaning run.
• Single-Use Design: Poly-spun filters are not cleanable -- replace on schedule to maintain consistent filtration performance.

Who Should Use This

Required replacement filter for HyperLogic system operators. Consistent sediment pre-filter replacement is essential for maintaining downstream component protection and overall system performance.

Compatibility

For use with HydroLogic HyperLogic systems. Replace monthly, or after each CIP cleaning run. Dimensions: 20in x 4.5in. Single use -- not cleanable.

Frequently Asked Questions

How do I know when to replace this filter?

Replace monthly, or after each CIP cleaning run. Watching for a noticeable flow reduction between scheduled changes is a good backup indicator.

Can this poly-spun filter be cleaned and reused?

No -- poly-spun melt-blown sediment filters are single-use only. Unlike pleated sediment filters, they cannot be effectively cleaned, so replace on the recommended schedule to maintain filtration performance.

What is the difference between melt-blown and pleated sediment filters?

Melt-blown polypropylene filters trap particles throughout the depth of the fiber matrix (depth filtration), while pleated filters capture debris primarily on the surface. Depth filtration provides high dirt-holding capacity for consistent performance over the filter's service life.

What size is this filter?

This filter measures 20in x 4.5in. It is sized specifically for HyperLogic housings, so confirm your housing dimensions before ordering.