Grow1 TechLock TEE Compression Fitting - 20mm - 25 Count

Tool-Free Tee Connections for Drip Lines - 25 Fittings

Splicing drip tubing with clamps or glue slows installation and makes later changes difficult. The Grow1 TechLock TEE compression fitting locks onto tubing with a push-and-twist motion, so you can build branches without special tools and reuse the fitting when the layout changes. It is rated for operating pressure from 0 to 100 PSI.

This unit contains 25 fittings, which suits growers building or expanding several branches across a hydroponic system, greenhouse, or irrigation run. A single unit gives small setups enough fittings to finish a project and keep spares.

Key Features & Benefits

• Push-and-twist locking — connects tubing quickly without clamps, glue, or tools.
• Reusable design — lets you rework a layout without replacing the fitting.
• Pressure range of 0 to 100 PSI — handles typical drip and hydroponic line pressures.
• Working temperature of 32°F to 140°F — suits normal growing environments.
• Dark finish — blends in with dripline tubing.

Who Should Use Grow1 TechLock TEE Compression Fittings

Growers, installers, and contractors who build or maintain drip, irrigation, or hydroponic lines and want fast, repeatable connections. It suits both home setups and commercial greenhouse work.

About Grow1 TechLock TEE Compression Fittings

Grow1 makes the TechLock line of compression fittings for drip tubing. This TEE fitting is a 20mm model for 1/4" or 1/2" drip tubing. It is designed for tubing with an inside diameter of 0.530" to 0.560", an outside diameter of 0.600" to 0.660", and a wall thickness of 0.035" to 0.050". Each unit holds 25 fittings.

Frequently Asked Questions

Q: What tubing does this fitting work with?
A: It is made for 1/4" or 1/2" drip tubing. Check that your tubing falls within the listed inside diameter, outside diameter, and wall thickness ranges.

Q: Do I need tools to install it?
A: No. You push the tubing in and twist to lock it. No clamps or glue are needed.

Q: Can I reuse the fittings?
A: Yes, the design is intended for easy reuse, which helps when you change a layout.

Q: What pressure and temperature can it handle?
A: Operating pressure is 0 to 100 PSI, and the working temperature range is 32°F to 140°F.

Q: What is a compression fitting?
A: A compression fitting grips the outside of a tube mechanically to form a seal. It avoids solvent glue and lets you disconnect the line when needed.

Q: How many fittings come in a unit?
A: Each unit contains 25 fittings.