Grow1 Black Vinyl Tubing - 3/16-in ID x 1/4-in OD - 100 ft

Flexible Black Line for Air and Water Runs - 100 ft Length

Long runs of tubing are hard to plan, and light passing through clear line can encourage algae inside it. This black vinyl tubing gives you one continuous length that you can cut to fit each connection, and its dark colour limits light reaching the water inside. It has a 3/16-in inner diameter and a 1/4-in outer diameter.

The 100 ft length suits growers who run several lines at once, such as a regular indoor grower plumbing a multi-site hydroponic setup, or a small commercial room. Hobbyists can cut what they need and keep the rest for later changes.

Key Features & Benefits

• 3/16-in inner diameter — fits accessories that call for a 3/16-in inside size, such as drippers and air stones.
• 1/4-in outer diameter — gives a defined outside size for planning fittings and routing.
• Black vinyl — a flexible material that suits both air and water lines.
• 100 ft length — lets you cut many separate runs from one roll.

Who Should Use Grow1 Black Vinyl Tubing

Use it if you build or maintain hydroponic systems, need air or water lines for indoor cultivation, or want a long length to cut to size. It suits home gardeners and licensed commercial growers alike.

About Grow1 Black Vinyl Tubing

Grow1 black vinyl tubing is sold as a single 100 ft length. It has a 3/16-in inner diameter, a 1/4-in outer diameter and a black colour.

Frequently Asked Questions

Q: What are the tubing dimensions?
A: The inner diameter is 3/16 in and the outer diameter is 1/4 in. The length is 100 ft.

Q: Can I use it for both air and water?
A: Yes. Vinyl tubing of this type is commonly used for air lines and low-pressure water lines in hydroponic setups. Check your fittings for a snug fit.

Q: Why choose black tubing over clear?
A: Black tubing blocks much of the light that can encourage algae in the line. Clear tubing lets you see flow and blockages, so choose by what matters more in your setup.

Q: What does inner diameter mean?
A: Inner diameter (ID) is the width of the hollow channel inside the tube. It determines which barbed fittings and accessories fit snugly in the line.

Q: How do I cut and connect it?
A: Cut it square with a sharp blade or tubing cutter, then push it onto a barbed fitting sized for a 3/16-in inner diameter. Warming the end slightly can make it easier to fit.

Q: Is this one roll or a multi-pack?
A: It is sold each, as a single 100 ft length.