Growonix Booster Pump with Splash Guard - 2.5 GPM - 150 PSI Max - 1/2-in Inlet x 3/8-in Outlet

Steady Water Pressure for Filtered Supply Lines - 2.5 GPM

Low incoming water pressure and cold water can slow filtered water output and leave irrigation lines short. This booster pump raises pressure in the line and includes a low pressure cutoff that protects the pump if the incoming supply drops. A liquid filled stainless steel gauge lets you read system pressure at a glance.

Sold as a single unit, it suits growers who need one dependable pressure-boosting stage for a filtration or hydroponic water line, whether in a home setup or a larger indoor facility that adds units as demand grows.

Key Features & Benefits

• Low pressure cutoff — shuts the pump down if incoming water pressure is lost, protecting it from running dry.
• Stainless steel liquid filled gauge — reads system pressure up to 300 psi.
• Manual or electric shutoff control — run it by hand or add the electric shutoff kit (ESOK).
• Low inlet pressure requirement — needs 30 psi of incoming pressure to reach full flow.
• Tube connections — 1/2-in tube inlet and 3/8-in tube outlet.

Who Should Use Growonix Booster Pump with Splash Guard

Choose it if your water filtration or irrigation line loses output to weak supply pressure. It fits home gardeners and commercial growers who run hydroponic systems on standard 110V power.

About Growonix Booster Pump with Splash Guard

Growonix makes water delivery and pressure-boosting equipment for cultivation. This pump moves up to 2.5 GPM at a maximum output pressure of 150 PSI. It runs on 110V 60Hz single phase power and draws 5.6A. It has no high pressure cutoff. It ships at 2.2 lb.

Frequently Asked Questions

Q: How much incoming pressure does it need?
A: It needs 30 psi of incoming water pressure to produce its full flow rate. Below that, output will fall short of the rated flow.

Q: What happens if my water supply drops?
A: The low pressure cutoff stops the pump when incoming pressure is lost. This protects the pump from damage.

Q: Does it have a high pressure cutoff?
A: No, it does not. Maximum output pressure is 150 PSI, so size your downstream fittings and tubing for that pressure.

Q: How do I control it?
A: You can switch it manually or add the electric shutoff kit (ESOK) for electric control. The kit is a separate accessory.

Q: What does a low pressure cutoff mean?
A: It is a safety switch that turns the pump off when inlet pressure falls below a set threshold. It prevents the pump from running without enough water.

Q: What power does it need?
A: It runs on 110V 60Hz single phase power and draws 5.6A. Confirm your circuit can carry that load.