EZ Clone Replacement Water Pump (Mag 750) , 700 GPH

OEM Replacement Water Pump for 64- and 128-Site Low Pro Systems

A failing pump is one of the most common reasons an aeroponic cloning system stops misting evenly, since every site depends on the same pump maintaining pressure through the manifold. The EZ-Clone MAG 750 Replacement Water Pump is the OEM part used in EZ-Clone's larger Low Pro systems, rated to circulate 700 gallons per hour through the reservoir and manifold.

It's built as a direct replacement for the pump shipped with EZ-Clone's 64-site and 128-site Low Pro systems, and also fits the original 60-site Low Pro system, so growers running any of those three configurations can order this exact part rather than guessing at compatibility.

Key Features & Benefits

• 700 GPH flow rate — matches the OEM pump specification for EZ-Clone's larger Low Pro systems.
• Direct OEM replacement — built to the same specification as the pump originally shipped with 64-site and 128-site Low Pro systems.
• Also fits the original 60-site system — cross-compatible with EZ-Clone's earlier 60-site Low Pro model.
• Submersible design — installs directly into the reservoir without external plumbing changes.

Who Should Order This Pump

This pump is for owners of an EZ-Clone 64-site, 128-site, or original 60-site Low Pro system whose existing pump has failed or is showing reduced flow. It's a maintenance part, not an upgrade, so it restores the system to its original specification rather than changing performance.

About EZ-Clone Replacement Pumps

EZ-Clone Enterprises sells the exact pump models used in its own systems as standalone replacement parts, so growers can service a Low Pro system without sourcing a generic aftermarket pump of uncertain fit or flow rate.

Frequently Asked Questions

How do I know if my pump needs replacing?

Weak or absent mist at most or all sites, unusual pump noise, or a pump that no longer primes are the typical signs of pump failure. If misting is uneven at only a few isolated sites, check the manifold or individual misters first before replacing the pump.

How do I install the replacement pump?

Unplug and remove the old pump from the reservoir, connect the new pump to the existing manifold line, and submerge it in the reservoir before refilling with water. Run the system briefly with water only to confirm even pressure before reloading cuttings.

Which EZ-Clone systems use this pump?

This MAG 750 pump is the OEM part for EZ-Clone's 64-site and 128-site Low Pro systems, and it also fits the earlier 60-site Low Pro model. It is not the correct pump for 16-site or 32-site Low Pro systems, which use a smaller MAG 450 pump.

What is the pump's rated flow?

It's rated at 700 gallons per hour, matching the flow rate of the pump originally shipped with these systems. Using a pump rated below that specification can reduce misting pressure across the full site count.

Is this pump submersible?

Yes, it's designed to sit directly in the reservoir rather than being mounted externally. No additional plumbing or external housing is required for installation.