DAB® JETCOM 132 Self-Priming Centrifugal Pump with Mas Control — 115V/230V Dual Voltage / 1.36 hp

Self-Priming Pump That Clears Its Own Air Bubbles

A conventional centrifugal pump loses its prime the moment air enters a suction line, forcing a manual restart before it can move water again. The DAB JETCOM 132 avoids that with an internal ejector mechanism that evacuates air from the suction line and re-primes itself automatically, a key capability for suction-lift setups, long intake lines, and systems where occasional air ingestion is unavoidable.

Rated at 1.36 hp on dual 115V/230V voltage, it delivers 1.8-46.2 GPM at up to 87 psi, and a lightweight, corrosion-resistant technopolymer body pairs with Mas Control electronic safety monitoring to protect against dry-running damage. This model replaces the Leader Ecotronic 130 (#LDRUS230001).

Key Features & Benefits

• Self-priming with internal ejector — handles air bubbles and minor solid ingestion without losing prime.
• Mas Control dry-run protection — automatically shuts down the pump when dry-running is detected.
• 115V/230V dual voltage — a single motor configures for either standard residential or commercial supply.
• 1.8-46.2 GPM flow range — supports small drip circuits up through large multi-zone irrigation systems.
• Technopolymer body — lightweight, corrosion-resistant construction for long service life.

Who Should Use This

Greenhouse operators and irrigation installers pulling water from tanks, cisterns, wells, or surface sources where intermittent air ingestion would stall a conventional centrifugal pump are the direct fit for the JETCOM 132.

About DAB

DAB Pumps has built self-priming and centrifugal pump technology since 1975, with the JETCOM line distributed in North America through DAB Pumps Inc.

Frequently Asked Questions

How far can the JETCOM 132 pull water from below?

Consult DAB's published performance curves for the pump's maximum suction depth at your specific flow rate. Self-priming capability varies with altitude and total line length, so check the curve that matches your installation.

Can this pump handle small amounts of sand or sediment?

The internal ejector can tolerate small quantities of sand without immediate damage, but prolonged sediment exposure accelerates wear. Add a pre-pump strainer for water sources with consistent sediment.

Does Mas Control restart the pump automatically after a dry-run shutoff?

Restart behavior varies by model generation. Consult DAB's JETCOM 132 installation manual for the specific restart procedure after a dry-run protection event.

Is this pump suitable for irrigating food crops?

It is rated for clean domestic and agricultural water supply. For food crop irrigation, confirm source water quality meets applicable safety standards and that no contamination risk exists in the wetted components.