Grow1 Barbed Straight Connector - 3/4-in - 10 Count

Join Hose Runs Securely - 3/4-in Barbed Fitting - 10 Count

Cut or damaged tubing leaves a gap in your water line, and a loose joint can leak or pull apart. The Grow1 Barbed Straight Connector bridges two hose ends with barbs that grip the inside of the hose. It fits 3/4-in inner diameter hosing, so you can repair a break or extend a run without replacing the whole length.

This unit contains 10 connectors. That suits hobbyists who want spares on hand and regular indoor growers who plumb or rework a few lines. Larger operations can reorder as their tubing needs grow.

Key Features & Benefits

• Barbed straight design — joins two hose ends in a straight line and holds them by gripping the inside of the tubing.
• 3/4-in inner diameter fit — matches hosing of that inner diameter.
• Durable construction — built to stay in service on hydroponic and water lines.
• 10 connectors per unit — keeps spares ready for repairs and layout changes.

Who Should Use Grow1 Barbed Straight Connector

Anyone running 3/4-in inner diameter hose in a hydroponic system, irrigation line or water transfer setup. It suits home gardeners and commercial cultivation teams who need a simple way to splice or extend tubing.

About Grow1 Barbed Straight Connector

Grow1 sells cultivation and hydroponics supplies. This straight connector is a barbed fitting for 3/4-in inner diameter hosing, and each unit contains 10 pieces.

Frequently Asked Questions

Q: What hose size does this connector fit?
A: It fits hosing with a 3/4-in inner diameter. Check your hose's inner diameter before ordering, since barbed fittings depend on a close match.

Q: How many connectors come in one unit?
A: Each unit contains 10 connectors. You order one unit to receive all 10.

Q: What does barbed mean?
A: Barbs are raised ridges on the fitting. When you push the hose over them, the ridges grip the inside wall and resist pulling off.

Q: Can I use it to repair a cut hose?
A: Yes. Cut out the damaged section, then push each clean end onto one side of the connector. The result is a continuous straight line.

Q: How do I get a secure fit?
A: Cut the hose square and push it fully over the barbs. Warming the hose end slightly can make it easier to seat.