Grow1 Barbed Plug Connector - 3/4-in - 10 Count

Cap Off Unused Hose Ends Cleanly - 3/4-in Barbed Plugs

Open hose ends leak, drain reservoirs and let debris into your lines. These barbed plugs seal the end of 3/4-in inner diameter hose so you can retire a line, cap a spare outlet or close off a run you are rearranging. The barbed body grips the inside of the hose, and the distributor describes the plug as durable.

Each unit holds 10 plugs, enough for a single indoor grow room, a trial hydroponic setup or a handful of spare lines. Commercial growers managing many runs can order several units to keep stock on hand.

Key Features & Benefits

• Fits 3/4-in inner diameter hose — matches common 3/4-in tubing runs in hydroponic systems.
• Barbed design — the ridges grip the hose wall so the plug stays seated.
• Durable construction — built for repeated use in wet environments.
• 10 plugs per unit — covers several lines without reordering.

Who Should Use Grow1 Barbed Plug Connector

Home gardeners and licensed commercial growers who run 3/4-in hose in hydroponic or irrigation systems and need to close off ends, spare ports or modified lines.

About Grow1 Barbed Plug Connector

Grow1 makes cultivation and hydroponics supplies. This barbed plug fits 3/4-in inner diameter hosing and is sold as one unit containing 10 plugs.

Frequently Asked Questions

Q: What hose size does this plug fit?
A: It fits hose with a 3/4-in inner diameter. Check your hose's inner diameter, not its outer diameter, before ordering.

Q: How many plugs come in one order?
A: Each unit contains 10 plugs. Ordering one unit gives you 10 plugs.

Q: What does barbed mean?
A: A barbed fitting has raised ridges around its body. The ridges press into the inside of the hose and resist pulling out.

Q: How do I install a barbed plug?
A: Push the plug into the hose end until the barbs are fully seated. Warming the hose end slightly can make insertion easier. Test for leaks once water is running.

Q: Can I use it to seal a line I plan to reopen later?
A: Yes. Pull the plug out when you want to reuse the line. Inspect the hose end first and trim it if it is damaged.