Grow1 Barbed Plug Connector - 1/2-in - 10 Count

Cap Unused Tubing Ends Securely - 10 Plugs

Open tubing ends leak, lose pressure and let debris into the line. The Grow1 Barbed Plug Connector pushes into hosing with a 1/2-in inner diameter and closes it off. Its barbed body grips the inside of the hose, and the plug is built to be durable.

Each sale holds 10 plugs, a practical quantity for a home grower capping a few spare lines or a small indoor setup that gets reconfigured between cycles. Larger operations can reorder as needed for many drip or feed lines.

Key Features & Benefits

• Barbed design — grips the inside of the hose so the plug stays seated.
• 1/2-in inner diameter fit — matches common 1/2-in hosing used in hydroponic systems.
• Durable construction — holds up to repeated use and reconfiguration.
• 10 plugs included — covers several lines with spares on hand.

Who Should Use Grow1 Barbed Plug Connector

Growers who run hydroponic or irrigation tubing and need to close off a branch, end a line or pause a section will find this plug useful. It suits hobby and commercial cultivation setups alike.

About Grow1 Barbed Plug Connector

Grow1 makes cultivation and hydroponics supplies. This barbed plug fits 1/2-in inner diameter hosing and is sold as a 10-count unit.

Frequently Asked Questions

Q: What hose size does this plug fit?
A: It fits hosing with a 1/2-in inner diameter. Check your tubing's inner diameter before ordering.

Q: How many plugs come in one order?
A: One unit contains 10 plugs.

Q: What does barbed mean?
A: A barbed fitting has raised ridges that press into the inside wall of the hose. The ridges resist the fitting pulling out.

Q: When would I use a plug instead of a valve?
A: Use a plug for an end you do not plan to open often. A valve suits lines you want to open and close regularly.

Q: How do I install it?
A: Push the barbed end firmly into the cut end of the hose until it is fully seated. Softening the hose end in warm water can make this easier.