Active Aqua 3/4" Straight Connector, Pack of 10

Push-Fit Tubing Connector for Hydroponic Runs, 3/4"

A hydroponic tubing run only stays leak-free if every joint uses a fitting actually sized for that tubing, and a mismatched connector either won't seal or restricts flow at the joint. Active Aqua Straight Connectors are sized push-fit fittings built from chemical-resistant material for joining and repairing runs of the matching tubing diameter, sold in a pack of 10 for growers maintaining multiple lines.

This 3/4" connector matches 3/4" tubing used across reservoirs, drip systems, and nutrient delivery lines, and it's sized to that diameter only.

Key Features & Benefits

• Push-fit installation — no barbed fitting, clamp, or tool required for a standard install.
• Chemical-resistant construction — holds up to nutrient solution contact without degrading.
• Sized for a specific tubing diameter — matches the connector to the tubing rather than forcing a universal fit.
• Pack of 10 — covers multiple joints or repairs across a reservoir or drip system without reordering.

Who Should Use This Connector

Growers building, extending, or repairing hydroponic tubing runs — reservoirs, drip systems, nutrient delivery lines — who need a same-diameter connector on hand are the fit for this product.

About Active Aqua

Active Aqua's tubing hardware line, distributed through Hydrofarm, covers the connectors, fittings, and reservoir accessories that keep a hydroponic plumbing run built and repaired with parts sized to match, rather than improvised adapters.

Frequently Asked Questions

What tubing size does this 3/4" connector fit?

It's sized specifically for 3/4" tubing. Using it on a different diameter line won't give a reliable, leak-free seal, so match the connector to your tubing before ordering.

How does the push-fit installation work?

Push the tubing ends into either side of the connector until they seat fully, with no barbed fitting, clamp, or tool required. A properly seated push-fit connection resists pull-out under normal reservoir pressure.

Is it safe for use with nutrient solution?

Yes, it's built from chemical-resistant material intended for ongoing contact with nutrient solution. That resistance is what keeps the fitting from degrading or leaching into the solution over repeated use.

How many connectors come in a pack?

Each pack contains 10 connectors. That's usually enough to cover several joints or repairs across a reservoir or drip system without a separate reorder.

Can I use this to repair a cut or damaged line instead of a full replacement?

Yes, splicing in a connector at the damaged section is a common repair instead of replacing the entire tubing run. Cut cleanly on both sides of the damage before pushing the tubing into the connector.