Active Aqua 3/4" Elbow Connector, Pack of 10

90-Degree Push-Fit Elbow for Hydroponic Tubing, 3/4"

Forcing hydroponic tubing around a tight corner without a fitting built for the turn kinks the line and chokes flow right at the bend. Active Aqua Elbow Connectors turn a tubing run 90 degrees cleanly, so flow stays steady around corners and tight bends instead of pinching down at a forced kink, and they're sold in a pack of 10 for growers building out multi-line layouts.

This 3/4" elbow matches 3/4" tubing used across reservoirs, drip systems, and nutrient delivery lines, and it's sized to that diameter only.

Key Features & Benefits

• 90-degree turn — routes tubing around corners without kinking the line.
• Matched to one tubing diameter — keeps the elbow sized to the line instead of relying on a universal-fit design.
• Push-fit, no-tool install — seats by hand without a barbed fitting, clamp, or additional tool.
• Pack of 10 — covers multiple corners or repairs across a reservoir or drip system without reordering.

Who Should Use This Elbow Connector

Growers routing hydroponic tubing around corners, tight spaces, or equipment — where a straight run would kink — are the fit for this connector.

About Active Aqua

Active Aqua's tubing-connector lineup, distributed through Hydrofarm, covers elbows like this one alongside the brand's straight connectors and reservoir fittings.

Frequently Asked Questions

What tubing size does this 3/4" elbow fit?

It's sized specifically for 3/4" tubing. Using it on a different diameter line won't give a reliable, leak-free seal at the bend.

How does it prevent kinking?

It provides a pre-formed 90-degree turn for the tubing to route through, so the line never has to bend sharply enough on its own to pinch shut. A kinked line restricts flow right at the bend, which this fitting avoids entirely.

How does the push-fit installation work?

Push the tubing ends into either side of the elbow until they seat fully, with no barbed fitting, clamp, or tool required. Once seated, the joint holds against normal reservoir pressure without slipping loose.

How many elbows come in a pack?

Each pack contains 10 elbow connectors. That's usually enough to route several corners across a reservoir or drip system without a separate reorder.

When would I use an elbow instead of a straight connector?

Use an elbow anywhere your tubing run needs to change direction by roughly 90 degrees, such as routing around equipment or into a reservoir from above. Use a straight connector instead when you're only joining or repairing a run without changing its direction.