Active Aqua 1" T Connector, Pack of 10

Push-Fit Branch Connector for Hydroponic Tubing, 1"

Branching a hydroponic line to feed a second run usually means cutting the existing line and splicing in a fitting built for the job, rather than tapping in with an improvised joint. Active Aqua T Connectors branch one line into two with a push-fit tee, sold in a pack of 10 for growers building out multi-line layouts.

This 1" T Connector matches 1" tubing used across reservoirs, drip systems, and nutrient delivery lines.

Key Features & Benefits

• Branches one line into two — adds a second line without cutting the original run short.
• Cut for a single tubing diameter — keeps the tee matched to the line rather than a one-size-fits-all fitting.
• Tool-free push-fit seating — no barbed fitting, clamp, or tool needed to install it.
• Pack of 10 — covers multiple branch points across a reservoir or drip system without reordering.

Who Should Use This T Connector

Growers adding a branch line to an existing tubing run — extending a drip system or splitting reservoir feed lines — are the fit for this connector.

About Active Aqua

Active Aqua's push-fit connector lineup, distributed through Hydrofarm, includes this T Connector alongside the brand's straight connectors and elbow fittings.

Frequently Asked Questions

What tubing size does this 1" T Connector fit?

It's sized specifically for 1" tubing. Using it on a different diameter line won't give a reliable, leak-free seal at the branch point.

How does it branch a line without cutting it short?

The tee shape lets the original run continue through one side while the branch line taps off the third opening, so you're adding a line rather than interrupting the existing one. That's different from cutting a line and capping one end.

How does the push-fit installation work?

Push the tubing ends into each of the three openings until they seat fully, with no barbed fitting, clamp, or tool required. A fully seated tee joint stays put under normal reservoir pressure without needing a secondary clamp.

How many T Connectors come in a pack?

Each pack contains 10 T Connectors. That's usually enough to add several branch points across a reservoir or drip system without a separate reorder.

When would I use a T Connector instead of an elbow?

Use a T Connector when you need to add a branch line while keeping the original run continuous, and use an elbow when you're just changing the direction of a single line. A T Connector serves three tubing ends where an elbow only serves two.