Dosatron Bell Housing O-Ring - 11 & 14 GPM
City: US, Tewksbury
- Competitive Price Matching
- Fast & Discreet Shipping (2-3 days)
- Safe & Secure Shopping
- High Quality Trusted Brands
Replacement Seal for Dosatron Injector Housings - 11 & 14 GPM
A worn or flattened O-ring can let water seep from the bell housing of your injector and interrupt nutrient delivery. This replacement O-ring from Dosatron restores the seal at the housing joint, so the unit goes back to work without replacing the whole injector. It is a Dosatron part, listed for the 11 and 14 GPM models.
Sold individually, this O-ring suits growers who service their own equipment, whether you run a small hydroponic setup or maintain several injectors across a commercial operation. Keeping a spare on the shelf makes routine maintenance quicker.
Key Features & Benefits
- Bell housing seal — replaces the O-ring at the housing joint to help stop seepage.
- Made for Dosatron — a Dosatron-brand part for its injectors.
- 11 and 14 GPM models — matched to the flow-rate range listed for this part.
- Sold each — buy only what you need for a service.
Who Should Use Dosatron Bell Housing O-Ring
Use it if you own a Dosatron injector in the 11 or 14 GPM range and see a worn seal at the bell housing, or if you want a spare for scheduled maintenance of your nutrient delivery system.
About Dosatron Bell Housing O-Ring
Dosatron makes water-powered injectors used to dose nutrients and other additives into irrigation lines. This part, manufacturer part number JDI001, is the bell housing O-ring for its 11 and 14 GPM models.
Frequently Asked Questions
Q: Which injectors does this O-ring fit?
A: It is listed for Dosatron 11 and 14 GPM models. Check your injector's model against the manual or the manufacturer before ordering.
Q: How do I know the O-ring needs replacing?
A: Typical signs are water seeping at the bell housing joint, or a seal that looks flattened, cracked or hardened when you open the unit. Replacing a worn O-ring is a routine maintenance step.
Q: What is an O-ring?
A: An O-ring is a round rubber-style gasket that sits in a groove and compresses between two parts to form a watertight seal. In an injector, it keeps water from escaping at the joint.
Q: Is it cheaper to replace the O-ring than the injector?
A: In general, replacing a worn seal is a far smaller repair than replacing a whole unit. If leaking continues after a new O-ring, inspect the housing for other wear.
Q: How many come in an order?
A: One O-ring is sold per order.
No reviews found
