Aqua Master Tools Industrial Inline pH Electrode - 3/4-in Male Thread - BNC Connector - 6 Bar

Continuous Inline pH Monitoring for Pressurized Lines - 3/4-in Thread

Checking pH by hand leaves gaps between readings, and nutrient solution can drift in that time. This inline electrode mounts directly in the water line, so a compatible meter or controller reads pH as the solution flows. Its pressure rating of 6 bar suits pressurized plumbing, and its BNC connector fits a wide range of pH instruments.

Sold as a single electrode, this unit suits growers who run a fixed hydroponic system, a recirculating loop, or a commercial irrigation line and want a permanent sensor position. Home growers with a plumbed system can use it the same way as licensed commercial operations.

Key Features & Benefits

• 3/4-in male thread — screws into a matching fitting or sensor chamber in the line.
• BNC connector — connects to pH meters and controllers that accept a BNC input.
• 6 bar pressure rating — suits pressurized water lines.
• Industrial inline design — built for fixed installations rather than occasional dip testing.

Who Should Use Aqua Master Tools Inline pH Electrode

Use it if you manage nutrient solution in a hydroponic system, an irrigation line, or a flow-through setup and need pH read in place. It fits growers who add a controller or monitor to an existing pipeline.

About Aqua Master Tools Inline pH Electrode

Aqua Master Tools makes meters and controllers for hydroponics and water treatment. This industrial inline pH electrode has a 3/4-in male thread and a BNC connector, and it is rated to 6 bar for use in pressurized lines.

Frequently Asked Questions

Q: What does inline mean for a pH electrode?
A: An inline electrode mounts in the pipe or a sensor chamber so the liquid flows past it. You get readings from the line itself without taking samples.

Q: How does it connect to my meter?
A: It uses a BNC connector. Your meter or controller needs a BNC input, so check that before ordering.

Q: How do I install it?
A: Thread the 3/4-in male end into a matching female fitting or sensor chamber in your line. Seal the thread as your plumbing practice requires and keep the sensing tip wet.

Q: Is it suitable for pressurized lines?
A: Yes, it is rated to 6 bar. Keep system pressure below that rating.

Q: How is it different from a handheld pH pen?
A: A handheld pen gives a reading only when you dip it. An inline electrode stays in the line and supports continuous monitoring through a connected meter.

Q: Will it work with any controller?
A: Compatibility depends on the controller accepting a BNC pH electrode input. Confirm with your controller maker before installing.