Aqua Master Tools Industrial Inline EC / PPM / TDS / Temp Electrode - 6 Bar - 3/4-in Male Thread - BNC Connector

Continuous Nutrient Monitoring in the Flow Line - 3/4-in Thread

Checking nutrient strength by dipping a handheld meter only tells you about one moment. This inline electrode mounts in the line and reads EC, PPM, TDS and temperature as the solution flows past, so you see changes as they happen. It is rated to 6 bar and connects through a standard BNC connector.

This single electrode suits growers who run a recirculating or flow-through hydroponic system and want live readings on a compatible controller or meter, from a small indoor setup to a larger installation.

Key Features & Benefits

• Four measurements in one probe — EC, PPM, TDS and temperature from a single mounting point.
• 6 bar pressure rating — suits pressurised flow lines within that limit.
• 3/4-in male thread — screws into a matching fitting in a pipe, tank or sensor chamber.
• BNC connector — connects to measurement devices that accept a BNC input.

Who Should Use Aqua Master Tools Inline EC / PPM / TDS / Temp Electrode

Use it if you run hydroponic systems and want continuous monitoring of nutrient concentration and solution temperature without sampling by hand. It suits home gardeners building a monitored reservoir loop and commercial operations adding sensing points to a flow line.

About Aqua Master Tools Inline EC / PPM / TDS / Temp Electrode

Aqua Master Tools makes this industrial inline electrode for EC, PPM, TDS and temperature measurement. It has a 3/4-in male thread, a BNC connector and a 6 bar pressure rating. It is sold individually.

Frequently Asked Questions

Q: What does this electrode measure?
A: It measures EC, PPM, TDS and temperature. All four come from the same probe, so you need only one mounting point in the line.

Q: How does it connect to a controller?
A: It uses a BNC connector. It works with meters and controllers that accept a BNC sensor input, so check your device's input before buying.

Q: How do I install it?
A: Thread it into a fitting with a matching 3/4-in female thread in a pipe, tank or sensor chamber. Keep the system within the 6 bar pressure rating.

Q: What is the difference between EC, TDS and PPM?
A: EC is how well the solution conducts electricity, which rises with dissolved nutrient salts. TDS and PPM express that dissolved content as a concentration, so they are converted from the conductivity reading.

Q: How is an inline electrode different from a handheld meter?
A: A handheld meter gives a reading when you take a sample. An inline electrode stays in the flow and can feed readings continuously to a connected device.