Irritec P1 Drip Tape - 5/8-in - 8 Mil - 0.25 GPH - 8-in Emitter Spacing - 1000 ft
City: US, Tewksbury
- Competitive Price Matching
- Fast & Discreet Shipping (2-3 days)
- Safe & Secure Shopping
- High Quality Trusted Brands
Even Row Watering from One Long Roll - 1000 ft
Uneven watering across a long row leaves some plants stressed while others sit wet. Irritec P1 drip tape places an emitter every 8 inches, each rated at 0.25 GPH, so water reaches the root zone along the whole run at a steady, low rate.
This 1000 ft roll suits growers covering long beds, greenhouse rows or several benches. Home gardeners with a large plot can cut the tape to length and share one roll across many runs.
Key Features & Benefits
- 0.25 GPH emitters — a slow, steady flow that soaks the root zone without runoff.
- 8-in emitter spacing — close, even coverage along each row.
- 5/8-in diameter, 8 mil wall — a thin-wall tape sized for standard drip fittings of that diameter.
- Flap outlets — the outlet design is built into the tape for simple layout.
- 1000 ft roll — fewer joins on long runs.
Who Should Use Irritec P1 Drip Tape
Commercial growers, greenhouse operators and serious home gardeners who irrigate long rows or beds during vegetative growth and flowering.
About Irritec P1 Drip Tape
Irritec P1 is a flap-outlet drip tape in 5/8-in diameter with 8 mil wall thickness, 0.25 GPH emitters and 8-in spacing. It is sold as one 1000 ft roll under manufacturer part number P1-50825-08F-1000.
Frequently Asked Questions
Q: How far apart are the emitters?
A: Emitters sit 8 inches apart along the tape. This gives close, even coverage across a row.
Q: What does GPH mean?
A: GPH stands for gallons per hour, the flow rate of each emitter. This tape is rated at 0.25 GPH per emitter.
Q: What does 8 mil mean?
A: Mil is one thousandth of an inch and describes the tape wall thickness. Thicker walls generally resist handling wear better, while thinner walls cost less per foot.
Q: Can I cut the tape to length?
A: Yes, drip tape is made to be cut to the length of each row. Use fittings sized for 5/8-in tape to connect the cut ends to your supply line.
Q: Does it need a filter?
A: Drip emitters in general work best with filtered water because small particles can clog them. Check the manufacturer's data sheet for the recommended filtration and operating pressure.
No reviews found
