Grow1 Pre-Cut Green Vinyl Irrigation Whips - I.D. 3/16 in x 36 in - 25 Count

Ready-Cut Drip Lines That Block Light - 36 in Lengths

Cutting dozens of drip lines to length by hand takes time and gives uneven results. These Grow1 whips come pre-cut, so you connect them to emitters and fittings and move on. The opaque green vinyl blocks light, which limits algae growth inside the line.

This unit suits growers who want uniform lengths for a drip layout or hydroponic setup without measuring each run. It works for a small trial bed and for a regular indoor system alike, and you can order again as your setup grows.

Key Features & Benefits

• Pre-cut 36 in lengths — saves measuring and cutting during installation.
• Opaque green color — blocks light to help keep the line interior clean.
• 3/16 in inner diameter, 1/4 in outer diameter — suits standard barbed drip connections.
• Flexible vinyl (PVC) — routes easily around containers and fittings.
• Listed emitter compatibility — fits the Bowsmith Non-Clog Dripper Emitter models named in the FAQ.

Who Should Use Grow1 Pre-Cut Vinyl Irrigation Whips

Use these whips if you run drip irrigation or hydroponic systems and want consistent line lengths. They suit indoor growers, greenhouse operators and home gardeners.

About Grow1 Pre-Cut Vinyl Irrigation Whips

Grow1 makes cultivation and hydroponics supplies. This product is flexible vinyl (PVC) tubing in opaque green, cut to 36 in, with a 3/16 in inner diameter and a 1/4 in outer diameter.

Frequently Asked Questions

Q: Why is the tubing green and opaque?
A: The opaque color blocks light from reaching the water inside the line. That helps limit algae growth, which can clog emitters over time.

Q: Which emitters do these fit?
A: They fit Bowsmith Non-Clog Dripper Emitters, SKUs 6120-1000, 6120-200, 6123-1000, 6123-200 and 6124-1000. Check your emitter's barb size against the 3/16 in inner diameter before ordering other models.

Q: What do inner and outer diameter mean?
A: Inner diameter is the width of the water channel, here 3/16 in. Outer diameter is the width of the whole tube, here 1/4 in, and it matters when you match clamps and fittings.

Q: Can I use it for drinking water?
A: No. This tubing is intended for low-pressure fluid or air transfer and is not for potable drinking water.

Q: Can I shorten the whips?
A: Yes. Vinyl tubing cuts with a clean tubing cutter or sharp blade, so you can trim a whip to a shorter run.