Netafim Hanging Assembly Extension - 48in - Barb and Tube - For Sprinklers, Misters or Foggers

Barb-and-Tube Extension for Overhead Hanging Assemblies, 48in

A bench raised, a mounting point moved, or a taller crop added to a layout can all leave an existing hanging assembly too short to reach the intended hang height. Netafim's hanging assembly extension adds 48in of barb-and-tube length to an existing drop instead of requiring a full replacement assembly.

It connects with a standard barb-and-tube joint, matching Netafim's existing hanging assembly hardware for sprinkler, mister, and fogger installations.

Key Features & Benefits

• 48in barb-and-tube extension — adds reach to an existing hanging assembly instead of requiring a full replacement drop.
• Standard barb connection — joins directly to Netafim hanging assembly hardware without special adapters.
• Works across head types — extends drops used for sprinkler, mister, or fogger heads alike.

Who Should Use This

This extension fits growers who need more reach on an existing hanging assembly after a bench height change, mounting point relocation, or crop height change, without replacing the drop hardware already in place.

About Netafim

Netafim is an Israeli irrigation company credited with commercializing drip irrigation, and its hanging assembly line, including extensions, is built to support its overhead sprinkler, mister, and fogger product families.

Frequently Asked Questions

What is this extension used for

It adds 48in of additional length to an existing Netafim hanging assembly, for situations where a bench height change or mounting point relocation has left the current drop too short. It avoids the need to replace the entire hanging assembly.

How does it connect to an existing hanging assembly

It joins with a standard barb-and-tube connection that matches Netafim's existing hanging assembly hardware, so no special adapters are required. Installation takes only a couple of minutes per drop.

Does this work with sprinkler, mister, and fogger heads

Yes, since it extends the drop itself rather than the head, it works regardless of which of Netafim's overhead head types is mounted at the end of the assembly. The same extension can be reused if the head is swapped later.

Do I need to replace the whole hanging assembly if it's too short

No, this extension is designed specifically to avoid that. Adding 48in to the existing drop is a lower-cost fix than sourcing and installing an entirely new assembly.