Grow1 Pressure Compensating Junior Dripper Assembly - 0.5 GPH - 48-in - 25 Count

Steady Root-Zone Watering With No Assembly Work - 48-in Length

Uneven pressure across long runs, sloped benches or multi-level setups can leave some plants over-watered and others short. This assembly pairs a pressure compensating junior dripper with a drip stake on a length of 1/4-in tubing, so each plant gets a consistent 0.5 GPH across an operating range of about 10-58 psi. It arrives pre-assembled, so you connect the open end to your main line and push the stake into the growing medium.

This listing is one assembly, a good fit for trying the dripper on a few containers or adding single emitters to an existing layout. Growers who need many drip points can order it repeatedly, and the same format scales from a small tent to larger hydroponic installations.

Key Features & Benefits

• Pressure compensation — holds a 0.5 GPH flow across about 10-58 psi, so watering stays even along the line.
• Pre-assembled — dripper on one end, drip stake on the other, so no cutting or extra fittings are required.
• 48-in tubing — 1/4-in tubing gives you reach from the main line to the container.
• Drip stake — holds the emitter in place at the root zone.
• UV-resistant materials — suited to use in light-exposed growing spaces.

Who Should Use Grow1 Pressure Compensating Junior Dripper Assembly

Home gardeners and licensed commercial growers who water containers or hydroponic media with drip irrigation will find it useful, especially where pressure varies across the system or where low flow suits small pots.

About Grow1 Pressure Compensating Junior Dripper Assembly

Grow1 makes this assembly with a 0.5 GPH pressure compensating junior dripper and a drip stake on a 48-in length of 1/4-in tubing. The dripper operates across roughly 10-58 psi, and the materials are UV-resistant.

Frequently Asked Questions

Q: What does pressure compensating mean?
A: A pressure compensating dripper keeps its flow rate steady as line pressure changes. This helps plants at the start and end of a long run, or at different heights, receive similar amounts of water.

Q: What flow rate does it deliver?
A: It delivers 0.5 gallons per hour. That low rate suits small containers and slow, controlled watering.

Q: Do I need extra fittings?
A: The dripper and stake are already attached to the tubing. You connect the open end of the 1/4-in tubing to your main irrigation line.

Q: How long is each assembly?
A: Each assembly is 48 inches long. That gives you room to run from a main line to the container.

Q: Is it suitable for use under grow lights?
A: The materials are UV-resistant, so they are intended for light-exposed growing areas. Check your system layout for fit.