FloraFlex Multi Flow Bubbler - 8 Outlets - 1/2-in Inlet - 2, 6, 10 & 20 GPH Inserts

Set Flow Plant by Plant From One Manifold - 8 Outlets

Feeding many plants from one line often means uneven delivery, with some getting too much water and others too little. The FloraFlex Multi Flow Bubbler splits a single feed into 8 outlets and uses interchangeable flow inserts at 2, 6, 10 and 20 GPH, so you can match output to what each plant needs.

Sold as a single unit, this manifold suits growers building or adjusting a hydroponic drip layout, from a home garden to a larger room where you repeat the same setup across many stations.

Key Features & Benefits

• Four color-coordinated flow inserts — swap between 2, 6, 10 and 20 GPH to find the flow rate you want.
• 8-outlet manifold — feeds several emitters or plants from one connection point.
• Barbed ports for 1/4-in OD tubing — tubing pushes on for a straightforward connection.
• 1/2-in inlet — screws into the FloraFlex Quick Disconnect without threading.
• ABS construction — a rigid plastic body for irrigation use.

Who Should Use FloraFlex Multi Flow Bubbler

Choose it if you run a hydroponic or drip system and want adjustable flow across several plants from one valve. It suits growers who change flow between vegetative growth and flowering stages, or who want to tune individual stations.

About FloraFlex Multi Flow Bubbler

FloraFlex makes drip irrigation components for hydroponic cultivation. The Multi Flow Bubbler is an 8-outlet manifold with a 1/2-in inlet, barbed ports for 1/4-in OD tubing, and four interchangeable inserts at 2, 6, 10 and 20 GPH. It measures about 3 x 3 x 2.2 in and weighs 0.2 lb.

Frequently Asked Questions

Q: How many plants can one bubbler feed?
A: It has 8 outlets, so it can feed up to eight tubing runs. How many plants that covers depends on how many emitters you attach to each run.

Q: What flow rates can I choose?
A: The four inserts provide 2, 6, 10 and 20 GPH. You choose the insert that matches the flow you want.

Q: What tubing does it use?
A: The 8 barbed ports connect to 1/4-in OD tubing. Push the tubing onto the barb to connect it.

Q: How does it connect to my valve?
A: The 1/2-in inlet screws into the FloraFlex Quick Disconnect without threading. Check your own valve setup before ordering.

Q: What is a flow insert?
A: A flow insert is a small part that sets how much water passes through an outlet. Swapping inserts changes the flow rate without changing the manifold.