EZ Clone 360-Degree Replacement Mister, pack of 50

Uniform Mist Coverage for Aeroponic Cloning Systems, Pack of 50

Misters take the brunt of wear in an aeroponic system, since every cycle pushes water through the same small nozzle openings, and a worn or clogged mister shows up as inconsistent rooting long before anything else in the system fails. EZ-Clone's 360-Degree Replacement Misters are the spray heads used across EZ-Clone's Low Pro and Classic systems, engineered to throw mist evenly in every direction rather than in a fixed pattern.

This pack of 50 spray heads gives commercial growers enough replacement misters to refresh a full 128-site system with several sites to spare, or a home grower enough stock to service a smaller system for multiple seasons without reordering.

Key Features & Benefits

• 360-degree spray pattern — throws mist in all directions rather than a fixed cone, so root zones receive even coverage regardless of collar orientation.
• Fits EZ-Clone manifolds — sized to snap directly into the manifold and reservoir plumbing used across EZ-Clone systems.
• Consistent misting droplet size — designed to atomize water into a fine mist that supports oxygen exposure at the root zone.
• Bulk pack of 50 — covers a full system rebuild or extended replacement stock without reordering every cycle.

Who Should Replace Their Misters

Growers who notice uneven rooting, weak spray pressure, or visible clogging at individual sites should check and replace their misters before troubleshooting the pump or manifold. Commercial operations running frequent cycles typically replace misters on a set schedule rather than waiting for a visible failure.

About EZ-Clone Misting Hardware

EZ-Clone Enterprises designs its own misting components to work specifically with its Low Pro and Classic system manifolds, rather than relying on generic irrigation misters. The 360-degree design is standard across the EZ-Clone system line, so replacement misters cross-fit any EZ-Clone unit regardless of site count.

Frequently Asked Questions

How often should misters be replaced?

Most growers replace misters once a season or when they notice reduced spray pressure or visible clogging at a site. Commercial operations running continuous cycles may replace misters more frequently as part of routine maintenance.

How do I replace a mister?

Pull the worn mister free from its manifold port and press the replacement mister into place until it seats fully. No tools are required, and a full swap across a large system typically takes only a few minutes.

Do these misters fit every EZ-Clone system?

Yes, the 360-degree mister design is standard across EZ-Clone's Low Pro and Classic systems, so this pack fits any EZ-Clone manifold regardless of site count. It is not designed as a universal fit for other brands' cloning systems.

What causes a mister to clog?

Mineral buildup from hard water or nutrient residue left in the reservoir between cycles are the most common causes of clogging. Rinsing the system and misters thoroughly at the end of each cycle helps extend mister life.

Can I tell a clogged mister apart from a pump problem?

Check spray pressure at each individual site; if only a few sites show weak or absent mist while others spray normally, the misters at those sites are the likely cause rather than the pump. A pump-related issue usually shows up as weak pressure across the entire system instead.