DL Wholesale Hydro Hat Dripper - 9 in

Even Watering Around the Plant Base - 9 in Dripper

A single drip point often leaves dry pockets in a container, so water and nutrient solution never reach the whole root zone. The Hydro Hat Dripper spreads water through many pores around the base of the plant, which helps saturate the growing medium more evenly.

At 9 in across and 1 in tall, this single unit suits hobbyists trying out a new irrigation method and growers who fit one dripper to each container in an indoor or outdoor setup.

Key Features & Benefits

• Multiple pores — water is delivered around the container instead of at one spot.
• Open side — slips over a plant stalk without needing to remove or disturb the plant.
• 3 removable support stakes — hold the dripper in place and come out when you do not need them.
• Tubing connection — works with most ½ inch I.D. tubing.
• Flat 9 in profile — 1 in tall, so it sits low on the container.

Who Should Use DL Wholesale Hydro Hat Dripper

Growers who see uneven moisture in containers, or who want better coverage than a single emitter or stake gives, will find this useful in vegetative growth or flowering, indoors or outdoors.

About DL Wholesale Hydro Hat Dripper

The DL Wholesale Hydro Hat Dripper is a drip irrigation emitter sold each. It measures 9 x 9 x 1 in and ships at 0.4 lb. Its GTIN is 816731016551.

Frequently Asked Questions

Q: How is this different from a standard drip emitter?
A: A standard emitter or irrigation stake waters one point. This dripper releases water through many pores around the plant base, which covers more of the container surface.

Q: Can I fit it around a plant that is already growing?
A: Yes. It has an open side, so you can slip it over the stalk without having to lift the plant out.

Q: What tubing does it connect to?
A: It is compatible with most ½ inch I.D. tubing. Check your tubing's inner diameter before ordering.

Q: What comes in the box?
A: You get one dripper with 3 removable support stakes.

Q: What does I.D. mean on tubing?
A: I.D. is inner diameter, the width of the hollow channel inside the tube. It determines which fittings the tube fits.