CenturionPro HP3 Triple High Performance Bucker with Stand

Triple-Head HP Bucker with Stand for Large-Volume Destemming

The CenturionPro HP3 Triple High Performance Bucker with Stand multiplies the HP roller system across three simultaneous heads, each capable of accepting stems up to 3/4 inch in diameter. Three operators can feed simultaneously, delivering up to 500 lbs/hr wet or 100 lbs/hr dry — output that previously required 15 to 21 hand workers.

The HP3 runs on a single 120V, 20A circuit and uses three 0.75 hp IP54-rated gear-driven motors with variable speed control and reverse operation. Built from 304 stainless steel and anodized aluminum, it ships pre-mounted on a stand with industrial-grade casters. The 10-year warranty reflects the machine's commercial-duty construction.

Key Features & Benefits

• Triple HP Heads — Three simultaneous roller heads accept stems up to 3/4 inch across 5 hole sizes (3/16″, 1/4″, 3/8″, 1/2″, 3/4″).
• Throughput — Up to 500 lbs/hr wet or 100 lbs/hr dry across three heads.
• Variable Speed & Reverse — Each head runs independently with variable speed and reverse for jam clearing.
• Stand Included — Ships pre-mounted on a bucker stand with industrial casters for mobility.
• Construction — 304 stainless steel and anodized aluminum for durability and sanitation.
• Warranty — 10-year manufacturer warranty.

Who Should Use This Machine

The HP3 is built for large commercial operations that need high-volume destemming with minimal labor. Three simultaneous feed points allow multiple workers to keep pace with large harvest volumes. Its stand-mounted design and industrial casters allow repositioning in the harvest space.

Continuous-Feed Roller Destemming

The HP3's roller system uses neoprene rubber rollers to pull each stem through continuously. Unlike manual destemming or single-head machines, three heads running simultaneously dramatically reduce the bottleneck between harvest and trimming. Variable speed settings allow operators to match feed rate to plant condition — slower for dry, faster for fully hydrated stems.

Frequently Asked Questions

How many heads does the HP3 have?

The HP3 has three HP roller heads, each capable of accepting stems up to 3/4 inch in diameter.

What is the throughput capacity?

The HP3 processes up to 500 lbs/hr wet or 100 lbs/hr dry across all three heads combined.

Does it need a special electrical circuit?

Yes. The HP3 runs on a 120V, 20A single-phase circuit. It draws less than 7.5A operating.

Is a stand included?

Yes. The HP3 ships pre-mounted on a bucker stand with industrial casters included.

What is the warranty?

The HP3 Triple High Performance Bucker with Stand carries a 10-year manufacturer warranty.