CenturionPro HP3 High Performance Triple Bucker - 3 Workstations - 3 x 0.75 HP Motors - Stand Included

Three-Operator De-Stemming for Larger Harvests - 3 Workstations

Removing flowers from stems by hand slows down every harvest. The HP3 triple bucker gives three operators their own workstations on one machine. Two rollers at each station pull the stem through and pop the flowers off, so you can feed material continuously. Variable speed control lets you adjust the machine for wet or dry material.

This is an industrial machine for commercial operations with a three-person crew. It suits a processing room that handles regular, high-volume harvests. Small gardens will rarely need this much capacity.

Key Features & Benefits

• Three workstations — three operators de-stem at once, which raises throughput over a single-station machine.
• Five hole sizes per workstation — you can match the opening to the stem you are feeding.
• Three 0.75 HP gear driven motors with variable speed controller — you set the speed to suit wet or dry material.
• Stainless steel and anodized aluminum construction — the materials are durable and wipe clean.
• Stand with industrial casters included — you can roll the machine where you need it.

Who Should Use CenturionPro HP3 Triple Bucker

Commercial growers and processors with three people available to run the machine will get the most from it. It fits post-harvest rooms where de-stemming is a bottleneck.

About CenturionPro HP3 Triple Bucker

The HP3 is the triple-workstation model in the CenturionPro High Performance bucker line. It accepts stems up to 3/4 in diameter. It is rated for up to 500 lbs per hour wet or 100 lbs per hour dry. It plugs into a 110 volt, 20 amp circuit and carries a 10-year warranty. It is a special order item.

Frequently Asked Questions

Q: How many people does the HP3 need?
A: It is built for three operators, one at each workstation. Running it with a full crew uses its capacity best.

Q: What stem size can it handle?
A: It accepts stems up to 3/4 in diameter. Each workstation has five hole sizes, so you can pick the opening that fits your material.

Q: Can it process both wet and dry material?
A: Yes. The variable speed controller lets you adjust the machine for either. Rated throughput is up to 500 lbs per hour wet or up to 100 lbs per hour dry.

Q: What power does it need?
A: It plugs into a 110 volt, 20 amp circuit. Check that your room has a suitable circuit before ordering.

Q: Is the stand included?
A: Yes. The stand comes with industrial casters so you can move the machine.

Q: What does the gear driven motor setup mean?
A: Each workstation has its own 0.75 HP motor that drives the rollers through gearing. Gear drive delivers steady torque at adjustable speeds.