Hydrofarm Light Riser Hanging System w/Push Button Release, 1/8"

Push-Button Rope Ratchet Hanger for Grow Room Equipment

Raising or lowering a light by hand, one knot at a time, gets old fast once a plant canopy needs adjusting every few days through a grow cycle. This light riser hanging system uses a push-button release rope ratchet, so you squeeze the button and slide the equipment to a new height instead of retying anything.

Quick-release carabiner clips on each end let you swap the hanger between fixtures, and the 1/8in rope rating suits LEDs, reflectors, and carbon filters within that weight range rather than heavier equipment.

Key Features & Benefits

• Push-button release — adjust height by squeezing the button and sliding, no retying required.
• Quick-release carabiner clips — swap the hanger between fixtures without rethreading rope.
• 1/8in rope rating — sized for LEDs, reflectors, and carbon filters.
• Sold to hang equipment in pairs — use two rope ratchets per fixture for level, even support.

Who Should Use This Hanging System

Growers who adjust light or equipment height regularly as a canopy grows and want to do it in seconds without retying rope each time.

About Hydrofarm

Hydrofarm's product catalog spans grow-light hardware and mounting accessories alongside its original hydroponic equipment line, built on the company Stuart Dvorin founded in 1977 and has run from Petaluma, California since 1994.

Frequently Asked Questions

How do I adjust the height with this hanger?

Squeeze the push-button release on the ratchet and slide the rope to the new height, then let go to lock it in place. There's no retying or rethreading involved.

What can I hang with this system?

It's rated for 1/8in rope, which suits LEDs, reflectors, and carbon filters within that weight range. Heavier fixtures may need a hanger rated for a thicker rope.

How do the carabiner clips work?

Quick-release carabiner clips on each end let you unclip the hanger from one fixture and move it to another without rethreading the rope. That makes it faster to rearrange equipment as your setup changes.

How many of these do I need per light?

Most fixtures hang level and evenly supported on two rope ratchets rather than one, so plan on a pair per light or piece of equipment. Using just one can leave the fixture tilted.