PHOTOBIO PHOTO LOC CX Control Cable w/Ferrite, 0-10V, 3PF-3PM, 10'

Dedicated 10ft Control Cord Between Two CX Fixtures

PHOTOBIO CX fixtures share dimming signal directly between adjacent units rather than through the PHOTO LOC cabling used by MX, TX, and T fixtures, which calls for a control cord built specifically for that connection. This 10-foot straight cord links two CX fixtures directly, carrying 0-10V signal so a dimming command applied to one propagates to the other.

When two CX fixtures sit farther apart than 10 feet, multiple cords can be connected end to end to reach the needed distance.

Key Features & Benefits

• 10-Foot Straight Length — connects two adjacent CX fixtures directly on their dedicated signal bus.
• 22AWG Wiring with Ferrite Core — sized for CX fixture signal requirements, with noise suppression from the ferrite core.
• Push-Lock 3PF-3PM Connection — locks securely between fixtures to prevent accidental disconnection.
• Linkable End to End — extends spacing beyond 10 feet by connecting multiple cords in series.

Who Should Use This Control Cord

Growers running PHOTOBIO CX model LED fixtures who need to share 0-10V dimming signal between adjacent units, rather than routing through a separate MX/TX/T-style Communication Tree, should use this control cord.

About PHOTOBIO

PHOTOBIO's CX fixture line uses a dedicated fixture-to-fixture control cord rather than the broader PHOTO LOC Communication Tree used by its MX, TX, and T fixtures, since CX units are typically installed in adjacent rows sharing the same dimming schedule. This 10-foot cord is the standard connection between two CX units.

Frequently Asked Questions

What fixtures does this cord work with?

PHOTOBIO CX model LED fixtures specifically. It is not interchangeable with the PHOTO LOC cables used by MX, TX, or T fixtures, which use a different connector standard.

How long is this cord?

10 feet, connecting two adjacent CX fixtures on a straight run. Multiple cords can be linked end to end when fixtures sit farther apart than that.

What gauge wire does it use?

22AWG wiring with a ferrite core, sized specifically for CX fixture signal requirements. The ferrite core helps suppress electrical noise along the run.

Is this cord weatherproof?

Yes, it carries an IP66 rating, protecting against dust and water intrusion in demanding grow room environments. That is a slightly different rating tier than the IP67 cables used elsewhere in PHOTOBIO's cabling lineup, both suited to indoor and greenhouse use.