Grow1 Power Cord - 16 Gauge - 240V - 15 ft

Reach Your 240V Source Without Strain - 15 ft Cord

A ballast that sits too far from the outlet forces you to rearrange a room or run an unsuitable extension. This Grow1 power cord connects the ballast to a 240V power source, and it is rated for 13 amps and 1625 watts. It is UL listed.

This is a single cord sold each. It suits a grower who needs a replacement cord or one more cord for an added fixture in a small or mid-sized indoor room. Growers outfitting a larger room can order one cord per ballast.

Key Features & Benefits

• 15 ft length — gives you flexibility in placing ballasts away from the outlet.
• 16 gauge wire — matches the rated load of 13 amps.
• 240V rating — suits 240V lighting setups.
• Ballast-ready plug — fits the male power outlet on most major brand ballasts.
• UL listed — carries a recognized safety listing.

Who Should Use Grow1 Power Cord

Use this cord if you run a 240V ballast and need a replacement or a longer reach to your power source. It suits home growers and commercial rooms that need cords for each fixture.

About Grow1 Power Cord

The Grow1 16 gauge 240V power cord is 15 ft long and rated for a maximum of 13 amps and 1625 watts. One end plugs into the male outlet on a ballast, and the other connects to the 240V power source. It is UL listed.

Frequently Asked Questions

Q: What does this cord connect?
A: It connects a ballast to a 240V power source. The cord plugs into the male power outlet on the ballast, then into your 240V supply.

Q: Will it fit my ballast?
A: It fits the male power outlet on most major brand ballasts. Check the inlet on your ballast before ordering.

Q: What is the maximum load?
A: The cord is rated for 13 amps and 1625 watts. Keep the total load of your fixture below that rating.

Q: What does wire gauge mean?
A: Gauge describes the thickness of the wire conductor. This cord uses 16 gauge wire, which sets its amperage rating.

Q: Is it safe to use with 120V?
A: This cord is rated for 240V. Confirm your ballast and power source voltage before connecting anything.