Fluence PSU1/PSE2 DC Dimming Signal Cable - 5ft - Pigtail to M16 Push-Lock Connector

Carry the Dimming Signal from a PSU1/PSE2 to SPYDR 2 — 5ft M16 Push-Lock

The Fluence PSU1/PSE2 DC Dimming Signal Cable is the dedicated 5ft link between a PSU1/PSE2 power supply and SPYDR 2 fixtures using the M16 Push-Lock connector, telling the fixture driver how much to dim. The pigtail end terminates in bare wire leads for connection to the PSU1/PSE2 wiring harness or junction point.

Built with UL2464 rated wire and compliant with VW-1 flame test standards, the cable is engineered for reliable signal transmission in professional greenhouse and vertical farming environments where accurate light intensity control matters for crop consistency and energy management.

Key Features & Benefits

• Dedicated Dimming Signal Path: Carries the low-voltage control signal from the PSU1/PSE2 to the SPYDR 2 driver for precise, responsive intensity adjustment.
• M16 Push-Lock Connector: A push-lock connector provides fast, secure, tool-free installation at the fixture end.
• UL2464 Wire Construction: Consistent signal quality and construction standards for professional installations.
• VW-1 Flame Test Compliant: Meets this flame test standard for safety in commercial horticultural environments.
• 5ft Length: Matched to common spacing between a PSU1/PSE2 and SPYDR 2 fixture in commercial mounting configurations.

Who Should Use This

Greenhouse operators and vertical farm managers running Fluence SPYDR 2 fixtures with PSU1/PSE2 power supplies who want dimming control are the direct fit for this 5ft cable, since it is the correct OEM link between the PSU1/PSE2 signal output and the SPYDR 2 dimming input.

About Fluence Bioengineering

Headquartered in Austin, Texas, Fluence Bioengineering designs the signal and dimming cabling that connects its power supplies to its LED fixtures; it currently operates as part of Signify, the Philips lighting parent.

Frequently Asked Questions

What does a dimming signal cable do in a Fluence lighting system?

It carries a low-voltage control signal from the power supply to the fixture driver, telling it how much to dim the output. Without this cable connected, fixtures typically run at a fixed output level rather than responding to dimming commands.

How do I know this cable matches my power supply?

This cable is wired specifically for the PSU1/PSE2 power supply and its M16 Push-Lock dimming connector. Fluence uses different signal connectors and pinouts across its PSU lineup, so using the wrong cable can cause no dimming response or incorrect behavior.

How is the pigtail end connected?

The pigtail end terminates in bare wire leads that connect to the dimming signal input terminals on the controller, PSU wiring harness, or junction point. Follow Fluence's installation instructions for correct wire identification to avoid miswiring the circuit.

Is 5ft enough reach for my installation?

Signal cable length can affect dimming accuracy in some systems, so check that 5ft covers the distance between your PSU1/PSE2 and SPYDR 2 fixture before ordering. Consult Fluence support for guidance on maximum recommended lengths if you need to extend beyond it.