Fluence PSE1/Console DC Dimming Signal Cable - 10in - Pigtail to M16 Threaded Connector

Carry the Dimming Signal from a PSE1/Console to Legacy Fluence Fixtures

The Fluence PSE1/Console DC Dimming Signal Cable is the dedicated 10in link between a PSE1/Console power supply and grow light fixtures using the M16 Threaded connector, telling the fixture driver how much to dim without that connection, dimming is unavailable and the fixture runs at a fixed output. The pigtail end terminates in bare wire leads for connection to the PSE1/Console wiring harness or junction point.

Built with UL2464 rated wire and compliant with VW-1 flame test standards, the cable is engineered for reliable signal transmission in professional greenhouse and vertical farming environments where accurate light intensity control matters for crop consistency and energy management.

Key Features & Benefits

• Dedicated Dimming Signal Path: Carries the low-voltage control signal from the PSE1/Console to the fixture driver for precise, responsive intensity adjustment.
• M16 Threaded Connector: A threaded connector provides a mechanically secure, vibration-resistant fixture-end connection.
• UL2464 Wire Construction: Consistent signal quality and construction standards for professional installations.
• VW-1 Flame Test Compliant: Meets this flame test standard for safety in commercial horticultural environments.
• 10in Length: Matched to typical spacing between a PSE1/Console and fixture in standard commercial mounting configurations.

Who Should Use This

Greenhouse operators and vertical farm managers running Fluence RAZR 2/3/4, RAZRx, RAY, or SPYDR 1 fixtures with PSE1/Console power supplies who want dimming control are the direct fit for this cable, since it is the correct OEM link between the PSE1/Console signal output and the fixture's dimming input.

About Fluence Bioengineering

Fluence Bioengineering, an Austin, Texas company, engineers dimming signal cables and control hardware for its LED grow lighting systems; the company is currently owned by Signify, parent of the Philips lighting brand.

Frequently Asked Questions

What does a dimming signal cable do in a Fluence lighting system?

It carries a low-voltage control signal from the power supply to the fixture driver, telling it how much to dim the output. Without this cable connected, fixtures typically run at a fixed output level rather than responding to dimming commands.

How do I know this cable matches my power supply?

This cable is wired specifically for the PSE1/Console power supply and its M16 Threaded dimming connector. Fluence uses different signal connectors and pinouts across its PSU lineup, so using the wrong cable can cause no dimming response or incorrect behavior.

How is the pigtail end connected?

The pigtail end terminates in bare wire leads that connect to the dimming signal input terminals on the controller, PSU wiring harness, or junction point. Follow Fluence's installation instructions for correct wire identification to avoid miswiring the circuit.

Can I use a longer cable if 10in is not enough for my installation?

Signal cable length can affect dimming accuracy in some systems, so consult Fluence's technical documentation before extending beyond the standard length. Fluence support can advise on maximum recommended lengths for your specific PSE1/Console configuration.