Fluence AC Flex Wiring Junction Box Mount - 6in - M25 Push-Lock

Terminate AC Flex Trunk Wiring Cleanly at the Junction Box

The Fluence AC Flex Wiring Junction Box Mount provides a 6in pigtail-to-M25 Push-Lock connection point for bringing Fluence AC Flex wiring into a standard electrical junction box. Rated at 20A, this OEM mount gives installers a mechanically secure termination where the Flex wiring enters the box, keeping the sealed Fluence wiring system intact from junction box to fixture.

Because it is engineered specifically for Fluence's Flex wiring ecosystem, it avoids the fit and rating guesswork that comes with improvising a junction with generic hardware.

Key Features & Benefits

• 6in Pigtail Leads: Short, flexible conductors make clean, strain-free connections inside standard junction box enclosures.
• M25 Push-Lock Connector: Mates directly with Fluence AC Flex trunk cables, maintaining the sealed integrity of the wiring system.
• 20A Rating: Supports the current demands of Fluence's commercial fixture arrays on standard 20A branch circuits.
• OEM Fluence Component: Built to Fluence's specifications for direct, warranty-safe compatibility with its Flex wiring system.

Who Should Use This

Electrical contractors and installation teams commissioning Fluence VYPR 3, RAZRm, or SPYDR 2 systems with AC Flex wiring that terminates at a junction box are the direct fit for this mount, since it provides a professionally finished, code-consistent connection at every junction point.

About Fluence Bioengineering

Based in Austin, Texas, Fluence Bioengineering builds LED lighting systems and the junction and wiring hardware installers use to connect them; the company is currently part of Signify, parent of the Philips lighting brand.

Frequently Asked Questions

Is this mount required at every junction box in a Flex wiring run?

Yes, one junction box mount is required at each point where an AC Flex trunk enters a junction box enclosure. This provides the strain relief and sealed M25 Push-Lock connection point a compliant installation needs.

How do I know what junction box size to use?

Use a junction box with enough internal volume to accommodate the pigtail leads and any wire nuts or terminal connections required. A standard 4-inch square deep junction box is typically sufficient for a single-circuit termination.

Does this component work with every Fluence fixture line?

This mount is designed for VYPR 3, RAZRm, and SPYDR 2 series AC Flex wiring systems that use M25 Push-Lock connectors. Verify your specific fixture model and wiring system before ordering.

Does installing this require Fluence-certified training?

A licensed electrician familiar with low-voltage commercial lighting wiring can install this component. Always follow Fluence's installation documentation and ensure the work meets local electrical code for commercial grow room lighting.