Fluence PSU2 DC Dimming Adapter - 6in - M12 Threaded to M16 Push-Lock - VYPR 3/RAZRm

Bridge PSU2 Dimming Control to VYPR 3 and RAZRm Fixtures with Precision

The Fluence PSU2 DC Dimming Adapter is a 6in adapter cable with M12 Threaded input and M16 Push-Lock output, engineered to connect Fluence PSU2 dimming signal outputs to VYPR 3 and RAZRm series LED grow light fixtures. Where the PSU2 dimming connector does not directly interface with the VYPR 3 or RAZRm fixture connector, this OEM adapter bridges the gap - ensuring clean, reliable dimming signal transmission without improvised wiring solutions that can compromise signal integrity or system reliability.

Key Features & Benefits

• M12 Threaded to M16 Push-Lock - Converts the PSU2 M12 Threaded dimming output to the M16 Push-Lock interface used by VYPR 3 and RAZRm fixtures, providing a mechanically secure and electrically reliable connection at both ends.
• 6in compact length - The short 6in format allows the adapter to make a direct, low-slack connection at the fixture without introducing unnecessary cable runs that could act as signal antennas or create tripping hazards.
• OEM Fluence component - Manufactured to Fluence's specifications for full signal and mechanical compatibility within the PSU2 and VYPR 3/RAZRm wiring ecosystem.
• Enables precise 0-100% dimming - Passes the full PSU2 dimming signal range to the fixture, supporting complete light intensity management from full power down to minimum output for each fixture in the array.

Who Should Use This

Commercial growers and installation technicians setting up Fluence VYPR 3 or RAZRm systems with PSU2 dimming control who need the correct M12 to M16 adapter to complete the dimming signal circuit. A required component for any VYPR 3 or RAZRm installation where PSU2 dimming is specified.

Compatibility

Designed for use with Fluence VYPR 3 and RAZRm series LED grow lights with M16 Push-Lock dimming inputs, connected to a Fluence PSU2 unit with M12 Threaded dimming output. Not intended for SPYDR 2, SPYDR 2i, RAZR 2/3/4, RAZRx, or other Fluence fixture lines. Verify connector types before ordering.

Frequently Asked Questions

Is one adapter required per fixture or per PSU2 unit?

One adapter is required at each connection point between the PSU2 dimming output and the individual VYPR 3 or RAZRm fixture dimming input. In daisy-chain dimming configurations, the adapter is needed at the first fixture in each chain - refer to Fluence's wiring documentation for your array layout.

Will this adapter degrade dimming accuracy or response speed?

No - as an OEM Fluence component designed for this specific interface, the adapter introduces no measurable signal degradation, preserving the full accuracy and response speed of PSU2 dimming control.

Can I use this adapter with non-PSU2 dimming systems?

This adapter is designed for use within the Fluence PSU2 control ecosystem. Compatibility with third-party or other Fluence dimming systems will depend on connector type and signal voltage - consult Fluence technical support before using this adapter outside its intended application.

Are the M12 and M16 connectors weatherproof when engaged?

Yes - both the M12 Threaded and M16 Push-Lock connectors provide IP-rated seals when fully engaged, protecting signal wire connections from moisture in humid commercial grow environments.