Fluence DC PSU2 Dimming Adapter - 6in - SPYDR 2

Connect PSU2 Dimming Control to Your SPYDR 2 System with Precision

The Fluence DC PSU2 Dimming Adapter is a compact 6in adapter cable that enables PSU2 dimming signal connectivity for SPYDR 2 series LED grow lights. Where the standard dimming signal connector does not directly mate with a PSU2 dimming output, this adapter bridges the connection - ensuring clean, reliable 0-10V or compatible dimming communication between the PSU2 control system and the SPYDR 2 fixture without improvised wiring or signal integrity loss.

Key Features & Benefits

• PSU2-to-SPYDR 2 dimming compatibility - Provides the correct connector interface to pass dimming control signals from a Fluence PSU2 dimming system to SPYDR 2 series fixtures, enabling precise light intensity management across the array.
• 6in compact length - The short 6in form factor allows the adapter to make clean, direct connections at the fixture or driver without excess cable slack, keeping installations tidy and reducing the risk of connector stress.
• OEM Fluence component - Manufactured to Fluence specifications to ensure full signal compatibility and long-term reliability within the Fluence control ecosystem.
• Supports precision dimming - Enables full 0-100% dimming control of SPYDR 2 fixtures via the PSU2 system, allowing growers to fine-tune light intensity for different growth stages and energy management strategies.

Who Should Use This

Commercial growers and installation technicians configuring Fluence SPYDR 2 arrays with PSU2 dimming control who need the correct adapter to complete the dimming signal circuit. Essential for any SPYDR 2 installation where PSU2 dimming is required and the direct connector match is not available.

Compatibility

Designed for use with the Fluence SPYDR 2 series LED grow lights and the Fluence PSU2 dimming system. Not intended for SPYDR 2i, SPYDR 2x, VYPR 3, or RAZRm systems. Verify connector types on both the PSU2 unit and the SPYDR 2 fixture before ordering.

Frequently Asked Questions

Do I need one adapter per fixture or per PSU2 unit?

Typically one adapter is required at each connection point where the PSU2 dimming output connects to the SPYDR 2 fixture input. Consult Fluence's wiring documentation for your specific array configuration to determine the exact quantity needed.

Will this adapter affect dimming response or accuracy?

No - as an OEM Fluence component, the adapter is designed to pass dimming signals without introducing resistance, noise, or latency, preserving the full accuracy of PSU2 dimming control.

Is this compatible with third-party dimming controllers?

This adapter is designed for use within the Fluence PSU2 ecosystem. Compatibility with third-party 0-10V controllers will depend on connector type and signal voltage - consult Fluence technical support before using this adapter with non-Fluence control hardware.

Can this adapter be used outdoors or in high-humidity environments?

This adapter is intended for indoor commercial grow room use. Always protect connector interfaces from direct water exposure and ensure they are fully seated and locked to maintain signal integrity in humid environments.