Touch Spot + T Split Extension Cable

Watch Two Spots for Water With a Single WD-1

A single water detector normally reports from just one physical location, which is a limitation once a grower needs eyes on more than one spill-prone spot. The TrolMaster TSS-1 adds a second touch spot and a T-splitter to an existing WD-1 module, extending its water monitoring to a second location without adding a whole new detector unit.

It's built for horticulture, hydroponics, and similar applications where catching a spill, flood, or runoff early at more than one point matters.

Key Features & Benefits

• Second Detection Point — monitors two locations from a single WD-1 module.
• Direct WD-1 Connection — plugs directly into the existing water detector system.
• T-Splitter Included — branches the WD-1 connection to both touch spots.
• Plug-and-Play Setup — installs without extra configuration steps.

Who Should Use the TSS-1 Extension Set

Aqua-X system users who need to watch for spills, floods, or runoff at more than one location, but don't want to install a second WD-1 module, are the intended users of the TSS-1. It extends an existing detector rather than replacing or duplicating it.

About TrolMaster

TrolMaster expands the reach of a single WD-1 water detector with accessories like the TSS-1, engineered at the company's Sacramento, California headquarters so growers aren't forced into buying a second full module just to watch a second spot. That approach keeps a multi-point water-monitoring setup more affordable.

Frequently Asked Questions

What comes in the TSS-1 set?

A touch spot, a T-splitter touch spot, and a stab holder. Together they extend an existing WD-1 to a second monitoring location.

How do I install the TSS-1?

Connect the T-splitter into the WD-1's existing touch spot port, then plug both touch spots into the split ends. No additional configuration is needed beyond that physical connection.

What does the TSS-1 connect to?

The WD-1 water detector module. It is an extension accessory rather than a stand-alone sensor.

What is the TSS-1 used for?

Monitoring water spills, floods, or runoff at more than one point from a single WD-1. That's useful in horticulture and hydroponics settings with more than one spill-prone spot.

What conditions is the TSS-1 rated for?

32 to 122°F with working humidity up to 90%. Those ratings match typical indoor grow-room and greenhouse conditions.