32ft Extension Cable for IR emitter

Extend the Reach of Your IR Emitter

The IR emitter used with the ARS-1 AC Remote Station and the Beta-1 Digital Day/Night Remote Controller has to sit within line of sight of the equipment it's controlling, which isn't always close to where the controller itself is mounted. The TrolMaster ECS-8 is a 32 foot extension cable that solves exactly that placement problem.

It has a male end and a female end, dropping inline between the IR emitter and either the ARS-1 or Beta-1 controller with no change to how the emitter is normally wired.

Key Features & Benefits

• 32 Foot Length — extends the reach between the IR emitter and the controller.
• Inline Extension Fitting — adds length without rewiring the emitter or the controller.
• Seamless Connection — keeps signal quality consistent across the full extended run.
• Built for ARS-1 and Beta-1 — matches the connector and signal specification these two controllers use.

Who Should Use the ECS-8 Extension Cable

ARS-1 or Beta-1 controller users whose IR emitter needs to reach farther than the stock cable allows, often because the equipment being controlled sits well away from the controller's mounting point, need the ECS-8 to close that gap. It's specific to these two controllers rather than a general-purpose extension.

About TrolMaster

The ARS-1 and Beta-1 are part of TrolMaster's single-task controller tier, built at the company's Sacramento, California facility for growers who need one specific job automated, and the ECS-8 exists because IR line-of-sight requirements don't always match a convenient mounting location. It's a small accessory that solves a real installation constraint.

Frequently Asked Questions

How long is this cable?

32 feet. That covers most rooms where the IR emitter needs to reach equipment well away from the controller.

What is it compatible with?

The IR emitter used in the ARS-1 and Beta-1 controllers. It is not designed for other TrolMaster sensor types.

What kind of ends does it have?

A male end and a female end. That lets it install inline without modifying the emitter or the controller wiring.

What's the working humidity limit?

90% or less. That matches typical indoor grow-room conditions where these controllers are installed.