RJ12 to Female Barrel Cable Set

Wire Hydro-X to LED Drivers With Pigtail Connections

Many LED drivers terminate in a bare pigtail rather than a plug, which leaves no obvious way to connect them to a Hydro-X system's RJ12-based wiring without an adapter. The TrolMaster ECS-2 cable set bridges that gap, connecting the Hydro-X to LED drivers that use pigtail wiring through a terminal block built into the cable.

The set includes a 16 ft RJ12 cable, a Y-splitter, and a 4 ft RJ12-to-female-barrel cable; the two leads from an LED driver land on the terminal block, and each light in a room gets wired in sequence back to the Hydro-X LMA adapter.

Key Features & Benefits

• 16 Ft Male-to-Male RJ12 Cable — runs the primary connection to the Hydro-X controller.
• 4 Ft RJ12 to Female Barrel Cable — connects to LED drivers that use pigtail wiring.
• RJ12 T-Splitter Included — supports branching the run to additional fixtures.
• Terminal Block Connection — accepts the LED driver's two bare leads directly.

Who Should Use the ECS-2 Cable Set

Growers connecting LED drivers with pigtail wiring to a TrolMaster Hydro-X LMA adapter need the ECS-2 rather than a standard module cable set. It's specifically built for that terminal-block-style connection, not for wiring device stations.

About TrolMaster

TrolMaster builds several LMA-series lighting adapter cables like the ECS-2 because LED drivers across the industry don't share one universal connector, and the Sacramento, California company would rather stock the right adapter than force growers to splice wiring themselves. Matching cable to driver type is part of a proper Hydro-X lighting installation.

Frequently Asked Questions

What does this set include?

A 16 ft RJ12 cable, a 4 ft barrel cable, and a T-splitter. Together they cover the full run from the Hydro-X controller to the driver.

What kind of LED drivers is it for?

Drivers that use pigtail wiring rather than a plug-in connector. Drivers with threaded or PushLock connectors use a different ECS cable instead.

How are fixtures wired together?

Each light is wired in sequence back to the Hydro-X LMA adapter. This daisy-chain approach keeps a multi-fixture room on one control line.

What connector type does it use?

RJ12 on the controller end and a terminal block on the driver end. No soldering is required to make the connection.