HydroLogic Stealth-RO Sediment Pre-Filter Pleated Cleanable

HydroLogic Stealth-RO Sediment Pre-Filter Pleated Cleanable - Reusable RO Protection

The HydroLogic Stealth-RO Pleated Cleanable Sediment Pre-Filter provides effective sediment protection for Stealth-RO Systems with the added benefit of cleanability - simply rinse with a garden hose to restore flow and extend the filter's service life before full replacement is needed. Reducing silt, rust, dirt, sand, and sediment from your feed water, this pre-filter protects your Stealth-RO membrane and pump from premature fouling and wear.

Key Features & Benefits

• Cleanable Pleated Design: Pleated filter media can be rinsed clean with a garden hose, extending useful service life and reducing replacement frequency compared to non-cleanable sediment filters.
• Removes Silt, Rust, Dirt, Sand, and Sediment: Intercepts a broad range of physical contaminants before they reach the Stealth-RO pump and membrane.
• Stealth-RO System Fit: Sized at 10in x 2.5in for direct installation in Stealth-RO pre-filter housings with no modifications required.
• Protects RO Pump and Membrane: Clean feed water reduces abrasion on the RO pump and fouling on the membrane, extending the service life of costly system components.
• 6-Month Replacement Interval: Even with regular rinsing, full replacement every 6 months ensures maximum protection and consistent performance.
• Cost-Effective Maintenance: Cleanable design means fewer full replacements are needed, lowering per-year pre-filter operating costs versus single-use cartridges.

Who Should Use This

Ideal for operators of HydroLogic Stealth-RO Systems, particularly those with source water containing elevated sediment, sand, or rust that would rapidly clog a standard single-use cartridge filter. The cleanable design is especially practical in locations without convenient filter replacement access.

Compatibility

Designed for HydroLogic Stealth-RO Systems. Dimensions: 10in x 2.5in. Replace every 6 months regardless of cleaning history to ensure consistent pre-filtration performance. Not for use as a replacement in 20-inch housings without confirming housing compatibility.

Frequently Asked Questions

How do I clean the pleated pre-filter?

Remove the filter from its housing and rinse thoroughly with a garden hose, directing water from the clean side outward to flush trapped sediment from the pleats. Allow to dry before reinstalling if practical, or reinstall while wet if cleaning in-place during a maintenance cycle.

How many times can I clean and reuse the filter before replacing it?

The number of cleaning cycles before replacement depends on your water quality. As a guideline, replace after 6 months of use regardless of how many cleanings have been performed, as the filter media degrades over time even with regular cleaning.

How does this compare to a melt-blown sediment filter?

Pleated filters are cleanable and have higher surface area for lower initial pressure drop. Melt-blown depth filters offer finer particulate capture but cannot be cleaned. For coarser sediment protection where cleanability is valuable, pleated is the better choice.

Is this filter compatible with other 10in x 2.5in filter housings?

The 10in x 2.5in is a standard form factor compatible with many filter housings beyond the Stealth-RO. Verify thread type and end cap configuration match your housing before using in non-Stealth-RO applications.