HydroLogic HyperLogic Poly-Spun Sediment Pre-Filter 20in x 2.5in 5 Micron

HydroLogic HyperLogic Industrial Poly-Spun Sediment Filter -- 5-Micron Pre-Filter

The HydroLogic HyperLogic Industrial Poly-Spun Sediment Filter is a single-use, 5-micron melt-blown polypropylene sediment pre-filter engineered for use with HyperLogic Industrial water filtration systems. Capturing silt, rust, dirt, sand, and other suspended solids at a 5-micron level, this filter protects downstream filtration components, including RO pumps and membranes, from particulate damage and premature fouling. Installed in the stainless steel housing ahead of the RO membrane on Industrial and Heavy-Industrial Series systems, this pre-filter provides OEM-level protection for costly RO pump and membrane investments.

Key Features & Benefits

• 5-Micron Melt-Blown Filtration: Melt-blown polypropylene construction provides consistent 5-micron particle capture throughout the depth of the filter media, not just at the surface.
• Protects Downstream Components: Capturing sediment, rust, silt, and dirt before they reach RO membranes and pumps extends equipment service life.
• System-Specific Sizing: Dimensioned for exact compatibility with HyperLogic Industrial filter housings -- 20in x 2.5in for correct fitment and seal.
• Replacement Interval: Replace monthly, or sooner if pressure differential exceeds 10%.
• Single-Use Design: Poly-spun filters are not cleanable -- replace on schedule to maintain consistent filtration performance.

Who Should Use This

Required replacement filter for HyperLogic Industrial system operators. Consistent sediment pre-filter replacement is essential for maintaining downstream component protection and overall system performance.

Compatibility

For use with HydroLogic HyperLogic Industrial systems. Replace monthly, or sooner if pressure differential exceeds 10%. Dimensions: 20in x 2.5in. Single use -- not cleanable.

Frequently Asked Questions

How do I know when to replace this filter?

Replace monthly, or sooner if pressure differential exceeds 10%. Watching for a noticeable flow reduction between scheduled changes is a good backup indicator.

Can this poly-spun filter be cleaned and reused?

No -- poly-spun melt-blown sediment filters are single-use only. Unlike pleated sediment filters, they cannot be effectively cleaned, so replace on the recommended schedule to maintain filtration performance.

What is the difference between melt-blown and pleated sediment filters?

Melt-blown polypropylene filters trap particles throughout the depth of the fiber matrix (depth filtration), while pleated filters capture debris primarily on the surface. Depth filtration provides high dirt-holding capacity for consistent performance over the filter's service life.

What size is this filter?

This filter measures 20in x 2.5in. It is sized specifically for HyperLogic Industrial housings, so confirm your housing dimensions before ordering.