Anden A710V1 & A710V3 MERV 11 Replacement Filter

MERV 11 Round Replacement Filter for the Anden A710V1 and A710V3 Dehumidifiers

The Anden 5852 is the model-specific MERV 11 replacement filter shared by the Anden A710V1 and A710V3 variable-speed industrial dehumidifiers, since both units use the same physical chassis and differ only in voltage. Unlike the rectangular filters used on Anden's other capacity tiers, the 5852 uses a round, multi-pleat design.

The 5852 measures 24 inches round, matching the A710 series' larger air intake and higher continuous airflow volume compared with Anden's smaller dehumidifier tiers.

Key Features & Benefits

• MERV 11 Efficiency — Captures a high percentage of particles in the 1-10 micron range for equipment protection.
• Multi-Pleat Synthetic Media — Pleated construction increases surface area for filtration without adding airflow resistance.
• 24-Inch Round Design — Round profile matches the A710 series' larger air intake, unlike the rectangular filters used on smaller Anden tiers.
• Pre-Assembled Design — Arrives ready to install — no assembly, cutting, or reinforcements needed.
• Easy Access Installation — Anden dehumidifiers use an easy-access filter panel for quick swaps.
• Fits Both A710 Voltage Variants — The same 5852 filter fits both the 208-240VAC A710V1 and the 277VAC A710V3.

Who Should Use This Filter

The Anden 5852 is the correct replacement filter for either the Anden A710V1 or A710V3 dehumidifier, since the two share the same filter slot. Facilities running an A710-series unit near-continuously should keep a spare on hand given the unit's higher-duty variable-speed operation.

MERV 11 Filtration and Anden's Dual-Layer Design

Anden's dehumidifier replacement filters use a dual-layer, 100% synthetic media design. The upstream E-Layer is electrostatically enhanced, attracting and capturing smaller airborne particles beyond what simple mechanical interception can catch, while the downstream M-Layer captures larger particles by physical interception. Together, the two layers reach a MERV 11 rating — a finer level of filtration than the washable MERV 8 filter media used standard across Anden's smaller dehumidifier tiers — while still maintaining adequate airflow through the unit.

Frequently Asked Questions

What models does the 5852 fit?

The Anden 5852 fits both the A710V1 and A710V3 dehumidifiers, since the two models share the same physical chassis and differ only in electrical voltage. It won't fit Anden's smaller capacity tiers, which use rectangular rather than round filters.

What does MERV 11 mean?

MERV (Minimum Efficiency Reporting Value) 11 means the filter captures a high percentage of particles in the 1-10 micron size range. That's a meaningfully finer level of filtration than a MERV 8 washable filter while still allowing enough airflow through the dehumidifier to maintain its rated performance.

How often should this filter be replaced?

Replace the 5852 filter when it shows visible debris buildup or reduced airflow through the dehumidifier, or follow Anden's recommended schedule for your specific model and operating environment. Operations running dehumidifiers continuously in high-particle environments, such as active grow spaces, typically need to replace filters more often than a light-duty schedule calls for.

Is this filter pre-assembled?

Yes, this filter arrives fully assembled and ready to install, so no cutting, framing, or reinforcement is needed before it goes into the unit. Just remove the old filter through the access panel and slide the new one into place.

How is this filter shaped differently from Anden's other filters?

The 5852 is a 24-inch round, multi-pleat filter, unlike the rectangular filters used on Anden's A70 through A320 series dehumidifiers. That shape matches the A710 series' larger air intake design.