Temperature Device Station with cable set

Bring Heating and Cooling Under Automatic Control, 120V

A temperature device station brings a heater, cooler, or fan under direct Hydro-X control, so it switches automatically based on the temperature setpoints programmed into the controller rather than needing its own thermostat or manual switch. Wiring is limited to the equipment's power cord and one RJ12 connection back to the controller chain, with no rewiring of the device itself.

This 120-volt version switches heating or cooling devices rated up to 10 amps at 120 volts or less, matching standard North American outlets on a Hydro-X system.

Key Features & Benefits

• Automatic Temperature-Based Switching — activates connected heating or cooling equipment from the controller's setpoints.
• LED Status Indicator — shows the connected device's current on/off state at a glance.
• Address Assignment — identifies the station individually so several can run on one controller.
• Ready-to-Wire Cable Kit — bundles the 16 ft and 4 ft RJ12 cables and T-splitter needed for setup.

Who Should Use a TrolMaster Temperature Device Station

Growers who need a standard heater, cooler, or fan brought under automatic Hydro-X control, without rewiring the equipment or adding a standalone thermostat, are the right fit for a temperature device station. It's a common way to add heating or cooling capacity to a room as conditions change through the season.

About TrolMaster

Temperature device stations sit alongside TrolMaster's other Hydro-X modules, all engineered at the company's Sacramento, California facility to let a single-zone controller manage heating, cooling, humidity, and CO2 equipment through the same plug-in system. Growers typically mix several station types on one HCS controller as their equipment list grows.

Frequently Asked Questions

What kind of equipment can this station control?

It controls standard heating or cooling equipment, such as heaters, coolers, or fans. Devices must stay within the station's rated voltage and amperage.

Does the connected device need its own thermostat?

No, the station switches the device based on the temperature setpoints already programmed into the Hydro-X controller. A separate thermostat on the equipment itself isn't needed.

How do I know if the connected device is active?

An LED indicator on the station shows the connected device's current state. That gives a quick visual check without opening the controller's screen.

What hardware ships with the temperature station?

A 16 ft RJ12 cable, a 4 ft RJ12 cable, and a T-splitter ship with the unit. Those pieces connect it directly into an existing Hydro-X chain.