240V Program Device Station, Timer Control Relay w/ cables

240-Volt Multi-Function Timer and Pump Control

The DSP-2 program device station is the 240-volt counterpart to TrolMaster's program module, working as a flexible multi-function timer for any device rated up to 10 amps at 240 volts or less.

Like its 120V counterpart, the DSP-2 can run as a recycling timer with an optional maximum cycle count, or act as a master pump controller that activates automatically whenever a connected 24VAC irrigation zone turns on.

Key Features & Benefits

• Multi-Function Timer — Set specific times of day or night to activate any connected device.
• Recycling Timer Mode — Configure repeat cycles with or without a maximum cycle limit.
• Master Pump Control — Automatically powers a pump when any 24VAC irrigation zone activates.
• Plug & Play Setup — LED indicator and address assignment make installation straightforward.

Who Should Use the DSP-2 Program Device Station

Growers on a 240V Hydro-X or Aqua-X setup who need flexible, time-based or cycle-based control of an irrigation timer or master pump.

Specifications

Input and output voltage range from 100-240VAC at 50/60Hz with a 10A output current rating. Rated for working temperatures of 32-122°F and humidity of 90% or less. Includes a 16 ft and 4 ft RJ12 cable plus a T-splitter.

Frequently Asked Questions

What's the maximum load the DSP-2 can control?

Any device rated up to 10 amps at 240 volts or less.

Can the DSP-2 act as a master pump controller?

Yes, it can automatically power a pump whenever a connected 24VAC irrigation zone activates.

How is the DSP-2 different from the DSP-1?

The DSP-2 is built for 240 volt circuits, while the DSP-1 is built for 120 volt circuits.

What cables are included?

A 16 ft RJ12 cable, a 4 ft RJ12 cable, and an RJ12 T-splitter.