Anden A130 Commercial Grade Dehumidifier — 130 Pints/Day 120VAC MERV 11

130 Pints/Day of Cultivation-Built Humidity Control, A130

General-purpose dehumidifiers are not built for the moisture load a dense indoor canopy produces from transpiration, irrigation, and lighting heat, and running an undersized unit around the clock just to keep pace shortens its service life. The Anden A130 Commercial Grade Dehumidifier is purpose-built for cultivation, removing up to 130 pints of moisture per day at 310 CFM to hold the stable humidity that consistent Vapor Pressure Deficit management depends on.

At 920 watts and an energy factor of 2.6 L/kWh, the A130 pairs that capacity with efficient power use for continuous operation, and adds overflow protection against drainage failures during unattended operation.

Key Features & Benefits

• 130 Pints/Day at 310 CFM — meaningful moisture removal at an airflow rate that helps distribute humidity control evenly rather than only near the unit.
• 2.6 L/kWh energy factor — efficient moisture removal per unit of power consumed, keeping operating cost down over 24-hour cycles.
• Smart control integration — connects to compatible environmental control systems for sensor-driven humidity management instead of fixed timers.
• Self-sealing MERV 11 filter — captures airborne particulates common in grow rooms, protecting the canopy and internal components alike.
• Suspended, freestanding, or ducted install — adapts to a range of room layouts, with a positive pressure drain for flexible condensate routing.

Who Should Use the A130

Operators running a medium-density indoor grow room who need dedicated, continuously running dehumidification rather than a general-purpose HVAC dehumidifier will get the most from the A130's cultivation-specific design and smart-control compatibility.

About Anden

Anden builds its commercial dehumidifier line specifically for indoor cultivation under Therma-Stor LLC in Madison, Wisconsin, drawing on roughly 80 years of environmental-control manufacturing rather than adapting general HVAC equipment for grow rooms.

Frequently Asked Questions

How much moisture does the A130 remove?

The A130 removes up to 130 pints of moisture per day while moving 310 CFM of air. That airflow rate is part of what keeps humidity even across a grow room rather than just near the unit itself.

Can this unit connect to my environmental control system?

Yes, the A130 supports smart control integration with compatible environmental management platforms. That lets it respond to real-time humidity and temperature data instead of running on a fixed timer.

How is this different from a standard HVAC dehumidifier?

The A130 is engineered specifically for cultivation moisture loads and VPD management rather than general residential or commercial humidity control. It combines cultivation-specific capacity and filtration with the smart-control compatibility grow operations need.

What installation options does the unit support?

The A130 can be installed suspended, freestanding, or ducted, depending on the room layout. A positive pressure drain gives installers flexibility in condensate routing regardless of where the nearest floor drain sits.

How often does the filter need to be replaced?

Inspect the self-sealing MERV 11 filter monthly and replace it once it looks visibly loaded. Higher-particulate grow environments will load the filter faster than a typical HVAC setting, so treat monthly inspection as a starting point.