Anden A100 Commercial Grade Dehumidifier — 100 Pints/Day 120VAC MERV 11

100 Pints/Day of Cultivation-Built Humidity Control, A100

General-purpose dehumidifiers are not built for the moisture load a dense indoor canopy produces from transpiration, irrigation, and lighting heat, and running an undersized unit around the clock just to keep pace shortens its service life. The Anden A100 Commercial Grade Dehumidifier is purpose-built for cultivation, removing up to 100 pints of moisture per day at 280 CFM to hold the stable humidity that consistent Vapor Pressure Deficit management depends on.

At 750 watts and an energy factor of 2.6 L/kWh, the A100 pairs that capacity with efficient power use for continuous operation, and replaces the earlier Anden A95.

Key Features & Benefits

• 100 Pints/Day at 280 CFM — meaningful moisture removal at an airflow rate that helps distribute humidity control evenly rather than only near the unit.
• 2.6 L/kWh energy factor — efficient moisture removal per unit of power consumed, keeping operating cost down over 24-hour cycles.
• Smart control integration — connects to compatible environmental control systems for sensor-driven humidity management instead of fixed timers.
• Self-sealing MERV 11 filter — captures airborne particulates common in grow rooms, protecting the canopy and internal components alike.
• Suspended, freestanding, or ducted install — adapts to a range of room layouts, with a positive pressure drain for flexible condensate routing.

Who Should Use the A100

Operators running a medium-density indoor grow room who need dedicated, continuously running dehumidification rather than a general-purpose HVAC dehumidifier will get the most from the A100's cultivation-specific design and smart-control compatibility.

About Anden

Anden builds its commercial dehumidifier line specifically for indoor cultivation under Therma-Stor LLC in Madison, Wisconsin, drawing on roughly 80 years of environmental-control manufacturing rather than adapting general HVAC equipment for grow rooms.

Frequently Asked Questions

How much moisture does the A100 remove?

The A100 removes up to 100 pints of moisture per day while moving 280 CFM of air. That airflow rate is part of what keeps humidity even across a grow room rather than just near the unit itself.

Can this unit connect to my environmental control system?

Yes, the A100 supports smart control integration with compatible environmental management platforms. That lets it respond to real-time humidity and temperature data instead of running on a fixed timer.

How is this different from a standard HVAC dehumidifier?

The A100 is engineered specifically for cultivation moisture loads and VPD management rather than general residential or commercial humidity control. It combines cultivation-specific capacity and filtration with the smart-control compatibility grow operations need.

What installation options does the unit support?

The A100 can be installed suspended, freestanding, or ducted, depending on the room layout. A positive pressure drain gives installers flexibility in condensate routing regardless of where the nearest floor drain sits.

How often does the filter need to be replaced?

Inspect the self-sealing MERV 11 filter monthly and replace it once it looks visibly loaded. Higher-particulate grow environments will load the filter faster than a typical HVAC setting, so treat monthly inspection as a starting point.