Hydro Clone Cloning Collars - Purple Soft - 2-in - Neoprene - 35 Count

Soft, Light-Blocking Support for Cuttings - 35 Collars

Cuttings that sit loose in a cloning tray tilt, shift, and let light reach the stem base. These soft neoprene collars grip the stem gently and hold it upright in the slot. The opaque design shades the rooting zone, and the material is made in the USA.

One unit holds 35 collars at 2 inches (50.8 mm). That suits a hobbyist filling a single cloning tray, or a regular indoor grower who wants a ready set to rotate between cycles.

Key Features & Benefits

• Soft neoprene — grips the stem without a hard clamp.
• Opaque design — blocks light from the rooting area.
• 2-inch (50.8 mm) size — matches common 2-inch cloning slots and net pot openings.
• 35 collars per unit — enough to fill a tray in one go.
• Made in the USA — domestic manufacture.

Who Should Use Hydro Clone Cloning Collars

Growers who propagate cuttings in hydroponic or aeroponic cloning systems with 2-inch openings will find these useful. They work for home gardeners and for commercial propagation rooms that restock collars regularly.

About Hydro Clone Cloning Collars

Hydro Clone Cloning Collars are purple, soft, opaque neoprene collars in a 2-inch (50.8 mm) size. Each unit contains 35 pieces and is made in the USA.

Frequently Asked Questions

Q: What size are these collars?
A: They are 2 inches (50.8 mm). Check that your cloning tray or net pot opening takes a 2-inch collar before ordering.

Q: How many collars come in one unit?
A: One unit contains 35 pieces. It is sold as a single unit.

Q: Why does an opaque collar matter?
A: Opaque means it does not let light through. That keeps light off the stem base and rooting area inside the system.

Q: How do I fit a collar on a cutting?
A: Take a healthy cutting and slide the collar gently onto the stem near the base. Then set the collar and cutting into the tray slot or net pot so the stem end reaches the rooting solution or mist, following your system guidelines.

Q: Can I reuse them?
A: Rinse them in clean water and air dry them fully before the next cycle. Many growers also sanitize between cycles, then rinse well to remove any residue.

Q: What is a cloning collar?
A: A cloning collar is a soft ring that wraps a cutting's stem. It holds the cutting upright in a tray or net pot opening during rooting.