Hydro Clone Cloning Collars - Green Soft Neoprene - 2-in (50.8 mm) - 35 Count

Soft, Reusable Support for Cuttings - 2-in Collars

Cuttings that sit loose in a cloning tray tip over, shift, or let light reach the stem base. These soft neoprene collars grip the stem gently and hold it in place. The opaque material also helps shade the rooting zone from light.

This unit holds 35 collars, enough for a hobbyist starting a first batch of cuttings or a regular indoor grower refreshing a cloning setup. Because the collars are reusable, one unit serves repeated cloning cycles.

Key Features & Benefits

• Soft neoprene — cushions the stem while holding it upright.
• Opaque material — blocks light from the rooting area.
• Reusable — can be cleaned and used again between cycles.
• 2-in (50.8 mm) size — suits cloning slots and net pots of a matching size.
• Made in the USA — domestic manufacture.

Who Should Use Hydro Clone Cloning Collars

These collars suit home gardeners and licensed commercial growers who propagate from cuttings in hydroponic or aeroponic cloning systems and want a reusable way to secure stems.

About Hydro Clone Cloning Collars

Hydro Clone Cloning Collars are green, soft, opaque neoprene collars sized at 2 in (50.8 mm). They are made in the USA and supplied as 35 pieces per unit.

Frequently Asked Questions

Q: Can I reuse these collars?
A: Yes, they are reusable. Rinse them with clean water and let them dry fully before the next cycle.

Q: How do I clean them between cloning cycles?
A: Rinse off plant residue and debris, then dry completely. Many growers also sanitize between cycles and rinse thoroughly afterward. Follow your own system's sanitation guidance.

Q: Why does opacity matter?
A: Opaque material blocks light from reaching the rooting zone. Less light at the stem base helps cuttings root in a darker environment.

Q: What size are the collars?
A: Each collar is 2 in (50.8 mm). Check that your cloning slots or net pots match this size before ordering.

Q: How do I install a collar?
A: Slide the collar onto the stem near its base. Then seat the collar and cutting in your cloning slot or tray so it holds the stem snugly upright.

Q: How many collars come in a unit?
A: Each unit contains 35 collars.