Hydro Clone Cloning Collars - Green Soft - 2-in (50.8 mm) - Neoprene - 65-Pack

Soft Neoprene Grip for Steady Cuttings - 2-in (50.8 mm) Collars

Cuttings that shift or tip in a cloning tray root unevenly, and a rigid collar can pinch a tender stem. These soft neoprene collars cradle the stem and hold it upright. The opaque green material also helps keep light away from the rooting zone.

This 2-in (50.8 mm) collar size suits growers running cloning trays and chambers built around that opening, whether you propagate a few cuttings at a time or run regular cloning cycles. Check your system's opening before ordering.

Key Features & Benefits

• Soft neoprene — gives a gentle hold on delicate stems.
• Opaque design — limits light reaching the rooting area.
• 2-in (50.8 mm) size — matches cloning slots of that diameter.
• Made in the USA — a clear country of origin for buyers who check.

Who Should Use Hydro Clone Cloning Collars

Home gardeners and licensed commercial growers who propagate from cuttings in hydroponic or aeroponic cloning systems with a 2-in opening will find these useful.

About Hydro Clone Cloning Collars

These green, soft cloning collars are made from neoprene in the USA. Each collar measures 2 in (50.8 mm) and has an opaque design.

Frequently Asked Questions

Q: What size are these collars?
A: They are 2-in (50.8 mm) collars. Confirm that your cloning tray or chamber opening matches this size before you order.

Q: What are they made of?
A: They are made of neoprene, a soft, flexible material. It holds a stem without a hard pinch.

Q: Why does an opaque collar matter?
A: Opaque means the collar blocks light. Less light in the rooting zone helps limit unwanted growth there.

Q: Where are they made?
A: They are made in the USA.

Q: How do I use a cloning collar?
A: Slide the collar onto the cutting near its base. Then set the collar and cutting into your cloning slot so the stem end reaches the rooting solution or mist, following your system's guidance.