Hydro Clone Cloning Collars - Black Soft Neoprene - 2-in (50.8 mm) - 65 Count

Soft Opaque Support for Cuttings - 65 Collars

Cuttings that sit loose in a cloning site tip, bruise at the stem, or let light reach the rooting zone. These soft neoprene collars grip the stem gently and hold it upright. The black, opaque material blocks light from the rooting area, which helps limit algae growth around the cutting base.

One unit holds 65 collars in the 2-inch (50.8 mm) size. That quantity suits a hobbyist running a cloning dome and a small commercial propagation room that needs spares between cycles.

Key Features & Benefits

• Soft neoprene — cushions the stem instead of pinching it.
• Opaque black colour — keeps light away from the rooting zone.
• 2-inch (50.8 mm) size — matches the collar size listed for standard cloning sites of that diameter.
• Made in the USA — domestic manufacture.
• Reusable material — neoprene can be rinsed and cleaned between cycles.

Who Should Use Hydro Clone Cloning Collars

Use them if you propagate cuttings in hydroponic or aeroponic cloning systems and want a soft, light-blocking support. They suit home gardeners and licensed commercial growers alike.

About Hydro Clone Cloning Collars

These Hydro Clone collars are black, opaque neoprene inserts in a 2-inch (50.8 mm) size, made in the USA. The product page lists one unit as a pack of 65 collars.

Frequently Asked Questions

Q: What size are these collars?
A: They are 2 inches (50.8 mm). Check that your cloning system's sites accept a collar of this size before ordering.

Q: Why choose black, opaque collars?
A: Opaque material blocks light from reaching the rooting zone. That helps limit algae growth around the cutting base.

Q: What are they made of?
A: They are made of neoprene, a soft, flexible material. It holds a stem without a hard pinch point.

Q: How do I clean them between cycles?
A: Rinse off plant residue with clean water and let them dry fully before reuse. Many growers also sanitise reusable inserts between cycles, then rinse well to remove any residue.

Q: How many collars come in one unit?
A: One unit holds 65 collars. Store spares somewhere clean and dry until your next cloning cycle.

Q: Where are they made?
A: They are made in the USA.