Hydro Clone Cloning Collars - 2-in (50.8 mm) - Gray Soft Neoprene - 65 Count

Soft Neoprene Collars That Shade the Rooting Zone - 2-in (50.8 mm)

Cuttings that slump in a cloning site or let light reach the water invite stress and algae. These cloning collars use soft neoprene to grip the stem without a hard squeeze, and their opaque gray design blocks light from the rooting area.

Each unit holds 65 collars, enough to fill a cloning machine or tray for a full propagation run. That suits hobby growers starting a first batch and regular indoor growers who rotate cuttings often.

Key Features & Benefits

• Soft neoprene — cradles the stem for a secure hold.
• Opaque gray design — blocks light from reaching the rooting zone.
• 2-inch (50.8 mm) size — matches the common collar size used in cloning setups.
• 65 collars per unit — covers a full run of cuttings.
• Made in the USA — domestic manufacture.

Who Should Use Hydro Clone Cloning Collars

These collars suit hobbyist and professional growers who propagate cuttings in hydroponic or aeroponic cloning systems and want a soft, light-blocking support at each site.

About Hydro Clone Cloning Collars

This product is a set of 65 gray, soft neoprene cloning collars in a 2-inch (50.8 mm) size with an opaque design. They are made in the USA. The brand name appears in the distributor listing as Hydro Clone.

Frequently Asked Questions

Q: What are cloning collars used for?
A: A cloning collar wraps around a cutting's stem and holds it upright in a cloning site. It also keeps the cutting positioned at the right height above or in the rooting solution.

Q: Why does the collar color and opacity matter?
A: An opaque collar blocks light from the rooting zone. Less light there helps discourage algae growth in the reservoir or chamber.

Q: How many collars come in one unit?
A: One unit holds 65 collars, sold as a single item.

Q: How do I fit a collar to a cutting?
A: Take a healthy cutting with a clean cut and slide the collar gently onto the stem near its base. Then place the collar and cutting into the cloning site so the stem end reaches the rooting solution or mist, following your system's instructions.

Q: Will these fit my cloning system?
A: They come in a 2-inch (50.8 mm) size. Check that your cloning sites or net pots take a collar of that size before you order.

Q: Can I clean the collars between runs?
A: Rinse them with clean water to remove plant residue, then let them air dry fully. Cleaning between cycles helps keep the next batch of cuttings clean.