EZ-Clone Hard Cloning Collars, pack of 65

High-Density Collar Support for Aeroponic Cuttings, Pack of 65

A cloning collar's job is simple but easy to get wrong: hold the cutting steady over the mist chamber without pinching the stem or blocking light and airflow to the leaves. EZ-Clone's hard, high-density collars are cut to seat into any EZ-Clone system's lid, keeping cuttings upright while the stem stays free to develop roots undisturbed below.

This pack of 65 hard collars is manufactured from sterile material and fits every EZ-Clone cutting system, from the 16-site Low Pro up through the 128-site models. The larger 65-count pack suits growers running multiple systems or higher cutting volumes who don't want to reorder as often.

Key Features & Benefits

• Sterile material — each collar ships high-density clean, reducing the chance of introducing pathogens at the cut site.
• Exposes leaves to light and air — the collar design leaves foliage clear of the lid so leaves photosynthesize normally during rooting.
• Unrestricted stem in the misting chamber — the stem passes through without being pinched, so mist reaches the full cut surface.
• Universal EZ-Clone fit — sized to seat into the lid of any EZ-Clone cutting system, Low Pro or Classic.

Who Should Use These Collars

These collars fit any grower running an EZ-Clone system who needs to restock consumable collars between propagation cycles, whether that's a hobbyist running a 16-site unit or a commercial propagation room cycling through a 128-site system.

About EZ-Clone Collars

EZ-Clone Enterprises sells collars as a consumable accessory alongside its Low Pro and Classic cutting systems, offered in both soft foam and hard high-density material so growers can match collar firmness to cutting stem thickness.

Frequently Asked Questions

How many cuttings does one pack cover?

This pack contains 65 individual collars, enough for 65 cuttings in a single batch. Growers running a full 128-site system typically buy multiple packs to stock up.

How do I insert a cutting into the collar?

Slide the cutting's stem through the slit in the collar so the collar sits just below the leaf set, then seat the collar into the corresponding site on the system's lid. The stem should hang freely into the misting chamber without touching the collar's inner edge.

When should I switch from soft to hard collars?

Some growers prefer hard collars for thicker-stemmed cuttings that need firmer support, or for high-turnover commercial setups where collars see repeated reuse. The rigid material holds its shape better than foam under frequent handling.

Are these collars reusable?

Collars can be reused across multiple cycles as long as they're cleaned and show no visible cracking or wear. Replacing collars periodically is still good practice in a commercial rotation to limit pathogen buildup.

Do these collars fit every EZ-Clone system?

Yes, they're sized to fit the standard collar seat used across EZ-Clone's Low Pro and Classic system lines, from 16-site up to 128-site units. No adapters or modifications are needed.