TurboKlone® Replacement Reservoir — 11.5 gal — for Elite 144 Cloning Machines

Keep Your Elite 144 Cloner Running Clean Between Propagation Cycles, 11.5gal

A cloning machine reservoir that is hard to scrub down becomes a breeding ground for the root pathogens and algae that undercut clone success, and that risk only grows in a high-site-count machine like TurboKlone's Elite 144. This genuine replacement reservoir is molded with rounded interior edges instead of sharp corners, removing the hard-to-reach spots where residue and biofilm typically build up between propagation cycles.

Sized to match the Elite 144's site count, this 11.5-gallon reservoir holds enough solution for a full cloning cycle without mid-cycle refilling, while still being light enough for one person to drain, scrub, and reset between batches in a commercial propagation room.

Key Features & Benefits

• Rounded interior edges — removes the tight corners where root debris and biofilm collect, cutting down cleaning time between cycles.
• 11.5-gallon capacity — matched to the Elite 144's site count for a full cloning cycle before a refill is needed.
• Genuine TurboKlone replacement part — installs in place of the original Elite 144 reservoir without modification.
• Smooth, easy-clean surface — supports a consistent sanitation routine between propagation batches to protect root health.

Who Should Use This Reservoir

This fits growers running a TurboKlone Elite 144 Cloning Machine in a commercial propagation setup who need a replacement reservoir after the original cracks, stains, or becomes difficult to fully sanitize.

About TurboKlone

TurboKlone manufactures aeroponic cloning systems, including the Elite line used in commercial propagation operations, built around a temperature-regulated reservoir design intended to support dissolved oxygen at the root zone during misting cycles. The Elite 144 is one of the higher-site-count machines in TurboKlone's Elite lineup, aimed at operations propagating clones at commercial volume.

Frequently Asked Questions

Will this reservoir fit my Elite 144 machine?

Yes, this is a genuine replacement reservoir sized specifically for the TurboKlone Elite 144 Cloning Machine and installs in place of the original without modification. Confirm your unit's model designation before ordering, since TurboKlone sizes its reservoirs per machine.

How often should I replace the reservoir?

Most growers replace a reservoir once it cracks, stains beyond cleaning, or develops rough spots that make sanitation difficult. Since a hard-to-clean reservoir is a common source of root pathogen buildup in high-turnover propagation, an aging one is often worth swapping before it fails outright.

Why do rounded edges matter for cleaning?

Sharp interior corners trap residue, biofilm, and standing moisture that a scrub brush or cloth cannot easily reach. Rounding those edges removes those hiding spots, making it faster to fully sanitize the reservoir between propagation cycles.

Do I need to clean the reservoir between every batch of clones?

Yes, thorough cleaning between cycles is standard practice in aeroponic cloning, since a clean reservoir reduces the risk of root pathogens and pests carrying over into the next batch. A reservoir that is easier to clean makes this step realistic to keep up at commercial volume.

Does this reservoir work with TurboKlone's temperature control?

Yes, it matches the dimensions and fitment of the Elite 144's original reservoir, so it integrates with TurboKlone's reservoir-based temperature regulation without any additional parts. It does not change how the machine's misting or cooling components operate.